Sears 625.34929 owner manual Keep Your D Spensing, Dumensbonsand

Page 17

KEEP YOUR D SPENSING

If the dispensing system is exposed to the sun, replace the solution tubing every6 months. Re- place the tubing yearly if the system is installed indoors.

CLEAN THE STRAINER-- Before filling the tank

with solution, remove the strainer, remove the threaded fitting from the end of the strainer, then

clean by forcing water backwards through the strainer..

CHECK THE INJECTION FITTING --The plastic sleeve on the injection fitting helps to keep it clean and working_ However, check it every few months to keep it from plugging.

CAUTION: BE SURE TO TURN OFF WATER SYSTEM PRESSURE BEFORE REMOVING THE INJECTION FITTING.

DUMENSBONSAND

Electrical Voltage

115

AC

 

Frequency

 

60Hz

 

Amperage

 

37

 

Max. Pumping Rate

per

 

 

 

Hour

05

gals.

(1 89

Liters)

Max_ Pumping Rate per

 

 

 

24 Hours

12

gals.

(4&4

Liters)

Max. Water

System

Press

75 psi (5.27 kg/cm 2)

14-1/2"__

DIA

Reservoir

26"

 

Capacity

29-1!2"

15 gals. (56.8 Liters)

22"l

17

Image 17
Contents Model no SEAlS sOWT ONSPENS,NGSYSTEM Table of ContentsWhat does Your Solutjo Following briefly describes each of these water problemsHydrogen Sulfide Water -- Many water What Your Solut OIHas Your Water Supply had Chemical Keep a Record of Your Water System FactsPRE-TREATING Private Well Systems Treating Well WaterPUT Your Dispensing Damage From Solutions DUE to Where to Locate YourSystem where From Direct SunlightGuxdesto nNSTALL Your Pressure Tank Installed on the Main Supply LineTrical Connections TIP of the Injection Fitting IT is a Working PartSee page 11 to Make the Needed Elec Injection Fitting IT is a Working Part Solution Injection BetweenWell Pump and Pressure Tank See page 11 to Make the Needed ELEC- Trical ConnectionsVolt Outlet Wiring Diagram 115 Volt SystemWiring Diagram 230 Volt System RLL the Tank WnTH HOW to Check Chlorine ResidualIron and Hydrogen Sulfide Treatment Feed Control KnobWtreatment of Acid Water That Also has Above, the water is neutral, When feedingRLL the Tank WroTHSOLUT RELIEF-RELEASE Controls and FeaturesFill the Tank WnTH Keep Your DaSPENSUNG Removing and Cleaning the Pump HeadSuction Valve Discharge & Return to Supply ValvesReplacing the Diaphragm Keepyour DUSPENSnNGCheck the Diaphragm Dumensbonsand Keep Your D SpensingReturn Description 818382 811704KEY Partdescription 811703 8800418 14 L98013-188 16 U0816093 8800710AI S