Sears Freezer Single-Door ICE Service, Power Failure / Freezer Failure, Turningyour ICE Maker on

Moving: When moving the freezer, follow these guidelines to prevent damage:

•Disconnect the power cord plug from the wall outlet.

•Remove foods, then defrost, and clean the freezer.

•Secure all loose items such as base panel, baskets, and shelves by taping them securely in place to prevent damage.

•In the moving vehicle, secure freezer in an upright position to prevent movement. Also protect outside of freezer with a blanket, or similar item.

POWER FAILURE / FREEZER FAILURE

NOTE

Do not open freezer door unnecessarily if freezer is off for several hours.

If a power failure occurs, frozen foods will stay frozen for at least 24 hours if the freezer is kept closed. If the power failure continues, pack seven or eight pounds of dry ice into the freezer every 24 hours. Look in the Yellow Pages under Dry Ice, Dairies, or Ice Cream Manufacturers for local dry ice suppliers. Always wear gloves and use caution when handling dry ice.

If the freezer has stopped operating, see Freezer Does Not Run in the Troubleshooting Guide. If you cannot solve the problem, call Sears Service immediately.

If the freezer remains off for several hours, follow the directions above for the use of dry ice during a power failure. If necessary, take the food to a local locker plant until the freezer is ready to operate. Look in the Yellow Pages under Frozen Food Locker Plants.

ICE SERVICE

If your freezer has an automatic ice maker, it will provide a sufficient supply of ice for normal use. During the initial startup of your freezer, however, no ice will be produced during the first 24 hours of operation. Automatic ice makers are also optional accessories that may be installed in some models at any time. Call your local dealer for information.

TURNINGYOUR ICE

MAKER ON

After the plumbing
connections have been
completed, the water
supply valve must be
opened. Place the ice
container under the ice
maker, pushing it as far
back as possible. Lower
the wire signal arm to its
“down” or ON position.	Ice Maker
New plumbing
connections may cause

the first production of ice cubes to be discolored or have an odd flavor. These first cubes should be discarded until the cubes produced are free of discoloration and taste.

TURNINGYOUR ICE MAKER OFF

To stop the ice maker, lift the wire signal arm until it clicks and locks in the “up” or OFF position. The ice maker also turns off automatically when the ice container is full. If your model has an adjustable freezer shelf, place the shelf in the lower position, so that the wire signal arm will hit the ice when the container is full.

IMPORTANT

Check the leveling bracket on the ice maker to ensure the ice maker is level. If the gap between the freezer wall and the ice maker is the same at top and bottom, then the ice maker is level.

Your ice maker is shipped with the wire signal arm in the ON position. To ensure proper function of your ice maker, hook up water supply immediately or turn ice maker OFF by lifting the wire signal arm until it clicks and locks in the UP position.

Leveling Bracket

Ice

Container

1” or less

ICE MAKER TIPS

•Ice cubes stored too long may develop an odd flavor. Empty the ice container and ensure that the wire signal arm is in its “down” or ON position. The ice maker will then produce more ice.

•Occasionally shake the ice container to keep ice separated.

•Keep the wire signal arm in its “up” or OFF position until the freezer is connected to the water supply or whenever the water supply is turned off.

•The following sounds are normal when the ice maker is operating:

•Motor running

•Ice loosening from tray

•Ice dropping into ice container

•Running water

•Water valve opening or closing

•Wash the ice container in warm water with mild detergent. Rinse well and dry.

CAUTION

Do Not place the ice container in your dishwasher.

•Stop the ice maker when cleaning the freezer and during vacations.

•If the ice maker will be turned off for a long period of time, turn the water supply valve to the closed position.

6