SWITCH BETWEEN MODES
Press SELECT. The select mode will flash. The display will stop flashing if no key is pressed within 5 seconds.
CHANGE SETTINGS
Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options.
REMOTE UNIT SET UP
Up to 3 remote units can be used with this product to monitor outdoor temperature and humidity. The measurement unit (°C or °F) and channel number (1, 2, or 3) switches are located in the battery compartment, and should be set prior to installation.
EN
NOTE Additional remote units sold separately. If you are using more than one remote unit, be sure to select a different channel number for each unit.
INSTALLATION
Mount the remote unit on a flat surface using the recess holes on the back of the unit.
For best results:
•Before you insert the batteries, select the measurement unit and channel number first.
•Place the unit out of direct sunlight and moisture.
•Do not place the remote unit more than 20 – 30 meters (60 – 90 feet) from the main (indoor) unit.
9
| 11 | 8/8/03, 12:02 PM |