=Code, DliSPLAY, Tones | Sears 36725, 36729 guide

DELAYED ON AND OFF:

You can set the oven to turn on and off automatically. The control will calculate the ttme to start cooking.

Press COOK TIME.

2.Press UP or DOWN arrowto set how long you want to bake.

3.Press STOP TIME. The earliest stop time you can set will appear in the display.

4.Set STOP TIME (the time of day when you want the oven to turn OFF) by pressing the UP or DOWN arrow.

5.Press BAKE.

6.Select temperature by pressing UP or DOWN arrow. See Fig. 8.

INCREASE OR DECREASE TIME (

	INCREASE	OR DECREASE(
	TO SET STOP TIME
Fig.8	INCREASE	OR DECREASE (
Fig.8

TO SET TEMPERATURE

NOTE:

If the control beeps, you have not completed your timed oven setting. Press CLEAR!OFF and start again with Step 1.

The low temperature zone of this range (between 150°F and 200°F) is available to keep hot cooked foods warm. Food kept longer than two hours at these low temperatures may spoil.

Never let food, such as dairy products, fish, meat, poultry, etc., sit for more

than 1 hour before cooking starts when you set your oven for a delay start.

Room temperature promotes the growth of harmful bacteria. Be sure the oven light is off because heat from the bulb will speed bacteria growth.

DliSPLAY:

Once you have programmed your control for any operation, you can display the setting by pressing the appropriate pad. For example, if you are using the TIMER and want to see the time of day, press CLOCK. The display will show the time of day.

You cannot set BAKE, BROIL or COOK TIME while the oven door Is in the locked position. If you try, the word "door" will appear in the display. The oven door lock is to be used for Self-Cleaning only.

TONES:

The end-oFcycle tone will sound at the end of timer use and automatic oven functions. The end-of-cycle tone is 3 short beeps followed by 1 beep every 6 seconds that repeat until you press any operatiom If you would like to eliminate the repeating beeps, push and hold CLEAR/ OFF for ten seconds. To return the 1 beep every 6 seconds, push and hold CLEAR/OFF for 10 seconds.

To cancel the end-of-cycle tone, press CLOCK,

F=CODE:

If the time display beeps continuously and flashes an "F" followed by a number, you have a function error code. Notethe number after the "F". Press CLEAR/OFF. Allow oven to cool for 1 hour. If problem repeats, disconnect all power and gas to the range and call for service. Advise your service technician of the number following the "F" in the display.

NGCTL01