@UESTIONS and Answers, Before a Clean Cycle

BEFORE A CLEAN CYCLE

. Remove the broil pan and grid, oven racks, all utensils and any foil that may be in the oven. Do not try to clean utensils orany other objects in the oven during a self-clean cycle, nf oven racks are Deft in the

range during a cnean cycle, they willl darken, lose their luster and become hard to shale. If

you choose to leave the racks in the oven, you can polish the edges of the racks with steel wool and apply a small amount of vegetable oil to the rack edges after the self-clean cycle. This will make the racks easier to slide.

2_ Soil on the oven front frame, under the front edge of the cooktop (does not apply to built-in ovens), the door liner outside the door seal and the front edge of the oven cavity (about 1" into the oven) will not be cleaned during a clean cycle (see illustration). Clean these areas by hand before starting a clean cycle.

Use hot water with a soap-filled steel wool pad, then rinse well

3_ Wipe up heavy spiltovers on the oven bottom. Too much soil may cause smoking during the clean cycle.

. Clean the door seal by using a clean sponge to soak the soiled area with hydrogen peroxide. Repeated soaking may be needed depending on the amount of soil. Frequent cleaning will help prevent excessive soil buildup. Do not rub the door seal. The fiberglass material of the seat has an extremely low resistance to abrasion. An intact and well fitting oven door seal is essential for energy efficient oven operation and good baking results. If you noticethe seal becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should replace

the sealo

FRONT FRAME

DOOR SEAL

DOOR LINER

AFTER A CLEAN CYCILE

After a clean cycle, you may notice some white ash in the oven° Just wipe it up with a damp cloth.

If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle.

tf the oven is not clean after one clean cycle, the cycle may need to be repeated.

Note: Your oven light should be OFF during a self-

clean cycle to prolong the life of the bulb.

@UESTIONS AND ANSWERS

Q. if my oven clock is not set to correct time o_'

day, can ! still self-clean my oven?

A. Yes, however, if you desire to set a delay self-clean cycle to end at a specific time of day your clock should be set to the correct time of day.

Q. Can Duse commercial oven cBeaners on any

part of my self.cleaning oven?

A.No cleaners or coatings should be used on or around any part of this oven.

Q.Can Bclean the woven gasket around the oven door?

A.You can soak it with hydrogen peroxide as explained in the Cleaning Tips section of this manual. Be careful not to rub, move, or damage the gasket.

Q.Bs it normal to hear "crackming sound" during cleaning?

A.Yes. This is the metal heating and cooling.

Q.Why do ! have ash left in rny oven after cleaning?

A, Some types of soil will leave a deposit, It can be removed with a damp sponge or cloth,

Qm What should ! do if excessive smoking occurs during cleaning?

A_ This is caused by excessive soil and you should press CLEAR/OFF. Open windows to rid room of smoke. Allow the oven to cool for at least one hour before opening the door. Wipe up excess soil and reset the clean cycle.

Q_ Should there be any odor during the cleaning? A. Yes, there may be a slight odor during the first few

cleanings. Failure to wipe out excessive soil might also cause an odor when cleaning.

HGSCL05