Sears 71358, 71751, 71068 Adjusting the Air Adjustment Shutter if Necessary, Levelingthe Range

Page 38

Installation Instructions

STEP 8

Adjusting the Air Adjustment Shutter if Necessary

To determine if the oven burner flames are burning properly, first remove the oven bottom_

To remove the oven bottom:

I.

Remove

the knurled

 

j

-_

 

bottom

 

 

 

/t

:

 

2.

Grasp

the

oven

/

 

 

 

bottom

at

the

finger

 

 

 

 

slots

on

each

side°

Oven bosom

 

 

Remove the metal shield at the rear of the drawer cavity. The air adjustment

shutter is behind this shield, To adjust the flow of air to the burner, !oosen the

Phillips-head screw and rotate the shutter to allow more or less

air into the burner tube.

Loosen

shu_er

Metat shield

3.Lift the rear of the oven bottom enough to clear the lip of the range frame, then pull out.

With the oven bottom

STEP 9

Levelingthe Range

removed, properly adjusted flames should

have approximately

1" (2.5 cm) blue cones and, if range is

supplied with natural ._-_ gas, should burn with

no yellow tipping_ (With most LP gas, small yellow tips at the end of outer cones are norma!.) Flames should not lift off the burner ports. If lifting is

observed, gradually reduce air shutter opening until

1.Remove the storage drawer, panel_

2.Use a 3116" open-end or socket wrench to back out both rear leveling legs

approximately two turns°

3.Use a 1_" open-end or adjustable wrench to back out the front leveling legs

broiler drawer or ldck

J

)

 

/€

 

flames are stabilized_

The shutter for the oven burner is near the back wall of the oven and behind the broiler drawer. To remove the broiler drawer:

1.Pull the drawer out until it stops, then push it back in about i" (2.5 cm)

2.Grasp the handle, lift and pull the broiler drawer out,

two

turns.

/

4.Install the oven shelves in the oven and position the range where it wi!l be installed.

5.Check for levelness by placing a spirit level or a partially filled cup of water on one of the oven shelves. If using a spirit level, take two readings--

with the level placed diagonally first in one direction and then the other.

6.Adjust the leveling legs until the range is level.

7.After the range is level, slide the range away from the walt so that the Anti-Tip device can be installed.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Sears Read all instructions before using this appliance Important Safety InstructionsWhen You GetYour Range Have your range installedLet the burner grates and other surfaces cool UsingYour RangeTipping of the range, attach it to Important Safety Instructions co0 0u0d Surface CookingTechnician. Never use an open flame to locate a leak Clean only parts listed in this Use and Care Manual Important Safety Instructions 0o0 i00¢CleaningYour Range Baking, Broiling and RoastingOr reposidoned on shelfsupports Type of Cooktop Gas Burners How Does This Cooktop Your Old One?Compare to Radiant GlassLighting Instructions for Electric Ignition Models Surface CookingLighting Instructions for Standing Pilot Models To Light a Surface Burner Surface Cooking 0o0 o0odSurface Burner Controls After Lighting a BurnerStove Top Grills How to Select Flame SizeWok This Way On models with sealed burnersClock and Timer onsomomodo,s Some models UsingYour OvenBefore UsingYour Oven Oven ControlMelt ff left too Using Your Oven ooo ooodOven Shelves Shelf PositionsBaking How to SetYour Range for BakingPan Placement PreheatingPies Baking GuidesCookies Aluminum FoilAir Adjustment Shutter for Oven Burners Adjust the Oven Thermostat--Do It YourselTo Adjust the Thermostat Use of Aluminum Foil RoastingDual Shelf Cooking Frozen RoastsTo 6.8 kO Type Temperature Doneness MinutesRoasting Guide Questions & Answers How to BroilBroiling They should?Andlor Broiling GuideDosed during broiling MediumCare and Cleaning Burner HeadsCooktop Surface Or in a self-cleaning ovenDrip Pans Burner GratesTurn all the controls offbefore removing burner Care and Cleaning oo ooodWithout ALL BUtOq-ER Parts and Drip Parts and drip pans if so equippedBroiler Pan and Grid Control Panel and KnobsOven Air Vents Oven Light BulbLift-Off Oven Door Care and Cleaning co0t 00odOutside of door Inside of doorOven Bottom Removable Kick PanelThis special coating is not used on the oven shelves Care and Cleaning co0 000dCleaning Oven Interior Extinguish any open flame Installation InstructionsOpen windows Important Safety Instructions General Connect the Range to Gas Installation Instructions on ooodProvide Adequate Gas Supply For Models Rigid PipeHookup Equipped With SealedElectrical Requirements Installation InstructionsElectrical Connections Extension Cord CautionsWdl Be Disconnected Infrequently Seal the OpeningsElectric Disconnect Light the Pilots Installation Instructions o0 ,0uodAdjust the Surface Burner Pilots If Necessary Hght the Oven PilotCheck Ignition of Oven Burner Check Ignition of Surface BurnersSoft blue flames-- Normal for natural gas Hectric Ignition ModelsAdjusting the Air Adjustment Shutter if Necessary Levelingthe RangeConverting to LP gas Step Installing the Anti-Tip DeviceVENTILATION AIR to the Range is Questions? Before You Call for Service Make sure the drip pans are installed correctlyPage Part Kenmore GAS Range Warranty Americas Best Selling Appliance BrandSW/ARS

61018, 61111, 61118, 61061, 61011 specifications

Sears has been a staple in the retail industry for decades, and its line of products, particularly in outdoor equipment, has garnered attention from consumers looking for reliability and performance. Among the various items in their catalog, the Sears models 71751, 71068, 71351, 71168, and 71161 stand out for their innovative features and technologies.

The Sears 71751 is designed with a robust engine that delivers exceptional power for heavy-duty tasks. Its ergonomic design ensures user comfort, which is vital during extended use. The model is equipped with advanced cooling technology that prevents overheating, allowing users to complete their tasks without interruptions. With its versatile design, this equipment is suitable for both residential and commercial applications.

On the other hand, the Sears 71068 focuses on user-friendly operation. It features an intuitive control panel and a lightweight structure, making it easy to handle even for those new to outdoor equipment. This model boasts a high-efficiency engine that reduces fuel consumption while maintaining excellent performance, which is a critical factor for environmentally conscious consumers.

The Sears 71351 offers a unique blend of classic design and modern technology. This model is equipped with smart connectivity options, enabling users to monitor its performance through a mobile app. This feature adds value by allowing users to track maintenance schedules and operational efficiency, ensuring that the equipment functions optimally at all times.

The Sears 71168 is particularly known for its durability and all-weather capabilities. Constructed with heavy-duty materials, this model is resistant to corrosion and wear, making it ideal for outdoor use in various conditions. Furthermore, its noise-reduction technology ensures quiet operation, allowing users to work without disturbing the neighborhood.

Lastly, the Sears 71161 caters to those seeking a compact yet powerful solution. It features a foldable design that makes it easy to transport and store without sacrificing performance. This model also incorporates energy-efficient technology, making it an environmentally friendly option while delivering sufficient power for a range of tasks.

In summary, Sears models 71751, 71068, 71351, 71168, and 71161 showcase an impressive range of features that cater to different user needs. From robust engines to smart technology and eco-friendly designs, each model provides a unique solution for outdoor equipment challenges, reaffirming Sears' commitment to quality and innovation in the retail landscape.
Top Page Image Contents