INSTALLATION INSTRUCTIONS FOR YOUR NEW
FREE-STANDING
ELECTRIC RANGE
Before you begin - Read these instructions completely and carefully.
IMPORTANT - Save these instrucUons for local Inspector's use.
IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer. Be sure to leave these instructions with the Consumer.
Note to Consumer - Keep these Instructions with your Use and Care Book for future reference.
SAFETY
Besureyourappllance is properly Installed and grounded by a qualified technician.
All
To reduce the risk of bums or fire when reaching over hot surface elements, cabinet storage space above the €ooktop should be avoided. If cabinet
storage ° space is to be provided above the €ooktop, the risk can be reduced by Installing a range hood that sticks out at least 5" beyond the front of the cabinets. Cabinets installed above a cooktop may be no deeper than 13".
SR10095
Pub. No.
STABILITY DEVICE
TOOLS NEEDED:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
Bracket attaches to floor or wall to hold either right or left rear leg leveler. If fastening to floor, be surethat screws do not penetrate electrical wiring or plumbing. If this cannot be determined, use shorter screws that will not penetrate through flooring.
If the bracket came with your range, It Is shipped at- tached to the lower range back. Remove and discard the shipping screw that holds the bracket and then follow instructions below.
1.Decide whether the bracket will be Installed on the right or left side of range location.
(Stability device instructionscontinued on page 2,..)