(Stability device instructions continued...)
2.If the bracket side of the range Is adjacent to s cabinet, place the bracket against beck wall and cabinet as shown In Figure 1.
If there Is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Plane the bracket with Its outside edge at this location and agalnet back wall. See Figure 1.
3.Dstermlne whether you will anchor the bracket to the floor or wall. Fasten the bracket securely with the
screws provided. Screws are
tramlng. Ifattachlng to masonry you can buy sultable screws and anchors at hardware stores. Use a
masonry drill to drill the required holes.
ADJACENT CABINET OR FINAL |
| |
LOCATION OF RANGE SIDE | OUTSIDE EDGE OF | |
pANEL | __HTBRACKET | TO BE |
| ||
|
| FLUSH_IIErr LEFT ORE |
MINIMUM CLEARANCES
See Figures 2 end 3 for ell
The range may be placed with 0" clearance (flush) at the back wall and side walls of the range if the front edges of the range side panels stick out beyond the cabinet fronts st isast 1/4". See Fig. 3.
11L
18" MIN *
1
m
Fig. 1
4.Slide the range Into place. Be sure rear leg leveler gully engages slot In bracket. If range cannot be moved back far enough for rear leg leveler to enter bracket, move bracket forward as redulred and attach to floor In new lOCation.
5.If appliance Is removed for cleaning or any other reason, check to make sure bracket Is
BRACKET WALL
PLATE
SCREWMUSTENTER%'_
WOODOR METAL /
ATrACHMENT TO WALL
TOOL LIST
Phillips head SCrewdriver
1 3/8" open end or adjustable wrench 1/4" Hex Head screwdriver
i
MINIMUM DIMENSIONS BETWEEN COOKTOP,WALLS, AND
ABOVE COOKTOP
*RECOMMENDED SPACING TO HEAT SENSITIVE SURFACES. Fig. 2
ACCEPTABLE ELECTRICAL_
OUTLET AREA
I"2"
/ 61/2"
/"
PREFERRED ELECTRICAL
OUTLET AREA
Fig. 3
2