Miele KWT1611VI, KWT1601VI installation instructions Attaching and aligning, Custom door front

Installation
	When performing any work on the
	custom door, always observe the
	following:
	–	Always select the best load-bearing
		surface of the custom door as the
		location for screws.
	–	Select a screw length that is shorter
		than the thickness of the door front.
	Attaching and aligning the
^ Mark the distance X on the back-side	custom door front
of the custom door.	^ Fit the door handle to the custom
^ Also calculate and mark the center of		door.
the custom door Y.		Note that the screws are applied from
		the reverse side.

^Remove the mounting frame from the appliance door and position it

according to the markings on the custom door.

^ Pre-drill the holes.

^ Tightly screw on the bracket using the pre-drilled holes:

Attach the bracket to each attachment point with at least one screw.

^ Attach the bracket at the top with at

least 5 screws:

^ Open the upper door and hang the custom door with the adjusting rail over the double-threaded bolts p.

^ Screw the nuts q a few turns onto the double-threaded bolts. Do not

tighten completely.

The bracket includes a variety of holes

for the various design options of^ Close the door. custom doors.

54