Maytag RSW2700, RSW2400 Installation, Important Leveling Information, To adjust the front rollers

INSTALLATION

t:lemo_e and discard the cantilever shelf packing clips located just above eaeh shelf where it books onto the fi'ame. To remove the plastic clips, wiggle the clips sideways and pull straight ont.

Locating Your Refrigerator

1.Allow a free l]uw of'air through the front base grille. 9. "llmr model should not be installed where the room tel'llperature will go below 55 ° E, because it will not

run frequent b, enough to maintain proper temperature in the freezer,

:3. For ease of installation, ,v°u should leave a space of"

about 1/2 inch between the refi-igcrator and adjacent walls or cahinets. If"the refrigerator is placed _@h the

hinge side against a wall, you may want to leave

additional space so the door can be opened wider,

(Refer to the installation instructions for more detail.)

Important Leveling Information

Your refrigerator is equipped x_4thfront and back rollers so it can be moved myra' front the wall fur cleaning. The front rollers are a@tstahle and shonld he positioned so the refrigerator sits firmh' on the flonr and is level.

To adjust the front rollers:

l. Hemnve the hase grille by grasping the ends, Iif}and )ul] out.

if the t]oor is not level and it is neeessary to raise the rear of thc cabinet, we suggest, rollin(r the rear wheels onto apiece ofpI)weod or other shim materiah

4.To replace, center the clips in the cut-out areas and pnsh in until the hase grille snaps into place.

Connectingthe Appliance

WARNING,: This app]ianee is designed to operate

on a normal I15 volt, 15 amp, 60 c)cle line. There should be a separate, grounded circuit serving this

appliance only. Do not use an extension cord•

This appliance is equipped with a three-pronged gronnding plug for yoJtr protection against pnssihle electrical shock hazards. It nmst he plugged into a grounding receptacle. Where a standard two-prong wail

receptacle is encountered, it is the personal responsihilit) and obligation of the cnstomer to have it

replaced with a properly grounded three-prong wall

receptacle. Do not under an_ circumstances, cut or remove the third (grotmd) prong t)com the power cord.

Do no_ rise an adapter plug.

/_

®

: [

2.To ]exel the ret_'igerator, use a screwdriver and turn roller adjusting screws elocka_dse to lower the cahinet

or countereloeka_dse to raise the cabinet.

TURN CLOCKWISE TO

LOWER CABINET CORNER.

TURN COUNTER-

CLOCKWISE TO RAISE

CAmNETCORNER.

3.It is not necessary tn lock the refrigerator in place. However, if that is desirable, turn one or both of the

locking tSet elockavise. The) are located near the front wheels.

Energy Saving lips

1.Locate the refrigerator away from heat producing appliances sueh as the range or dishwasher, heat vents and direct sunlight.

2.Level the refrigerator and do not Nock xentilation around the front grille.

3.Keep the freezer full to near capacity so less cold air will escape during door openings. When less than

two-thirds full, place milk cartons half fhll of water in the freezer.

4.Let hot dishes cool slightly before putting into the refrigerator or freezer.

5.Cover liqnids.

6. Wipc moisture fron-tthe ontsidc of containcrs he}ore

placing them into the refrigerator.

7. Avoid opening the doors too often.

PAGE 1