Maytag RSW2200, RSW2400 Operating the Controls, Warm Cabinet Surfaces, Initial Setting Controls

OPERATING THE CONTROLS

Your new rcfrigcrator has two controls: one for the refrigerator compartment and one t_r the freezer compartment. These controls are located at the top, rear of the refrigerator compartment.

FREEZER		REFRIGERATOR
I		I
G	SE_ING	H_;OLDEST SETTING
[)	COLDESTINITIAL ETTING	64NITIALSE_ING

Initial Setting	of Controls			ADJUSTING	THE
Freezer Control:	This	cuntrol	has settings fi'om A
(warmest) to G (coldest)		Initially	set this control to D.	I NTE RI O	R

NOTE: Tile coldest freezer setting (G) is recom- mended for short term use only.

Refrigerator Control; This control has settings from 1 (warmest) to I1 (coldest). Initially set this control to 6. The refrigerator luay run for several hours when

you first start it. This is normal.

Let the refrigerator run at least 8 to 12 hours before adding food. A day or so after adding tbod,

you may decide one or both compartments should be colder or warmer. If so, adjnst the control(s) as instruct-

ed below.

Adjusting the Temperature Controls

Except when starting the refrigerator, do not change either control more than one number or letter at

a time. Allow 24 hours for the temperatnre to stabilize

before resetting. Chang •neo,. ether•co atrol _ fll have some effect on the temperature of the other compartment.

Freezer too warm--Tnrn tim freezer control to the succeeding letter. For example, turn the control from

D to E.

Freezer too cold--Turn the freezer control to the

preceding letter. For example, tnrn the control from D to C.

Refrigerator too warul Turn the refrigerator con- trol to the next higher number. For example, tunl the control fi'om 6 to 7.

Refrigerator too cold--Turn the refrigerator con- trol to the next lower number. For example turn the

control fi'om6 to 5.

Warm Cabinet Surfaces

Some portions of the cabinet may be warm to the touch. This is a normal function of the refrigerator

which helps prevent moisture fi'om condensing on the cabinet. This condition will be inure noticeable when

you first start your refi'igerator, during hot weather and after excessive or lengthy door ot)enings.

Sure-Loci( Shelves

The refrigerator shelves are adjustable, allowing you to arrange the shelxing to fit your famil>'s tbod storage

needs. Never attempt to adjust a shelf that is luaded with food.

To remove the refrigerator shelf:

1.Grasp the shelf at the front with one hand and pnsh up under the shelf back with the other hand.

9.Lili the shelf straight ont.

_ _

; ;

To replace the refrigerator shelf:

1.Keeping tile shelf horizontal, guide the three support

tabs into the slots in the shelf supports at the rear of the cabinet.

'2. Lower the shelf until the tabs lock into position. Make sure the shelf is securely locked into position

before loading it with fixed.

Easy-Glide Shelves

Grasp tile: front edge of the shelf and pull fonvard. Push i,_ shelf to return to the original position•

PAGE 3