If Something Goes Wrong
Before You Call For Service
Problem | Possible Cause | What to Do |
| ||
Oven will not | A fuse in your home | • Replace fuse or reset circuit breaker. |
start | may be blown or the |
|
| circuit breaker tripped. |
|
| Power surge. | • Unplug the microwave oven, then plug |
|
| it back in. |
| Plug not fully inserted | • Make sure the |
| into wall outlet. | oven is fully inserted into wall outlet. |
| Door not securely closed. | • Open the door and close securely. |
|
|
|
Floor of the oven is | The cooktop light is | • This is normal. |
warm, even when | located below the oven |
|
the oven has not | floor. When the light |
|
been used | is on, the heat it |
|
| produces may make the |
|
| oven floor get warm. |
|
|
|
|
“LOC” appears | The control has been | • Press and hold CLEAR/OFF for |
on display | locked. | about 3 seconds to unlock the control. |
|
|
|
Vent fan will not | The vent fan | • The vent fan cannot be turned off |
turn off | automatically turns on | while the microwave is operating. |
| to cool internal parts | This is normal. Wait for the microwave |
| while the microwave | to turn off and the fan will either go |
| is on. | off automatically or you will need to |
|
| turn it off by pressing the Vent Fan |
|
| pad after the microwave is off. |
|
|
|
“BAD PROBE” | The probe has not been | • Insert the probe properly into the |
appears on display | completely inserted into | oven wall outlet. |
| the oven wall outlet. |
|
| The probe is defective. | • Replace the probe. |
|
|
|
“PLEASE INSERT | Probe has been | • Insert the probe properly into the |
PROBE“ appears | forgotten or not | oven wall outlet. |
on display | inserted properly. |
|
“SENSOR ERROR” | When using a Sensor | • Do not open door until steam is |
appears on display | feature, the door was | sensed and time is shown counting |
| opened before steam | down on display. |
| could be detected. |
|
| Steam was not detected | • Use Time Cook to heat for more time. |
| in maximum amount |
|
| of time. |
|
36