GE 49-4560-1, JVM72 manual How Use, Start

How Use

Your H0L13/TIMER, which oper- ates without microwave energy, has three timing functions.

It operates as a Minute Timer, it can be set to delay cooking or may be used as a hold setting after defrosting. Hold/Timer can be set up to 99 minutes and 99 seconds.

Sfep 1: Touch HOLD/TIMER pad. The read-out panel shows :0. “~n- ter Time” flashes.

Step 2: Select the amount of time you desire. Touch the appropriate number pads, If, for example, you

are timing a three minute phone call, touch 3, 0 and 0, The readout panel shows 3:00 and “HOLD” appearson display.

Step3:Touch START.The readout display shows the time as it counts down, and “HoldTime Left”.

Step 4: When time is up, oven sounds.The readoutflashes“END” and the timer turns off.

The t-iOLDtTIMER can also be used to program “standingtime” between microwave cooking func-

tions. The time can range from one second to 99 minutes and 99 sec- ends. A HOLD,or “standing”time may be found in some of your own recipesor Cookbook.

To set the oven to delay cooking up to 99 minutes follow Steps 1 and 2 to enter hold time, then set time or temperaturedesired before pressingSTART,When holding be- fore temperature cooking, be sure probe is in food before pressing

START,

toDefrost-Hold/Time-Time

To help you become acquainted with the HQLD/TIMER feature as used with Time Cook or Temp Cook follow Steps below to defrost a frozen casserolefor 15minutes, then hold 10minutes and then cook 25 minutes. If using Temp Cook after Hold/Timer, be sure to insert probe correctly as shown in Automatic Roasting section of this book,

Step 1: Removecasserolefrom the freezer and place in oven. Touch the DEFROST pad. The readout panel shows “fEnterDef Time”, :0,

— and Power3.

--

Step 2: Touch 1, 5, 0 and O for defrosting time. Def Time, 15:(30, and Power 3 appear on the display panel. (Defrosting is automatically set on Power Level 3 but can be changed by touching POWER LEVEL pad and the rww Power Level,)

Cl. What will happen if I ;]cciden- tally reversethe instructic3ns’/

A.If you accidentally reverse the sequence of programming instruc- tions, your oven automatically rearranges your program. Defrost- ing always comes first, then hoM, and then the cooking function.

Wep 3: $%Xstanding or hold time by touching HC)LDITIMER,“Enter

Time” and :0appear on display.

Step 4: Touch 1,0, 0, and Oto hold for ten minutes, 10:00and *’I-KXJY’ appear on the display.

Q.Can I Defrost-l-bid only cm my oven?

A.Sometimes.you may want to de- frost a food, hold it, and refrigerate it to be cooked later, All you need to do is program in Defrost and amount of time. Then program Hotd and amount of time, Put your thawed dish in the refrigerator and cook later at a convenient time.

NOTE: Allow foods to remain at room temperature only as long as safe. Times will vary.

pad. The display shows “Enter Gook Time”, :0, and Power 10 (HIGH),

Step 6: Touch 2, 5, 0, and O for twenty-five minutes of cooking time. “Cook Time”, 25:00, and Power 10 appear on the dis- play panel,

Step 7: Touch START. ‘iDef Time Left”, Power 3, and 15:00counting down show on display. As each function is automatically per- formed oven display shows en- tered information.

Q. I programmed my oven for a specific defrosting time but it de- frosted longer than necessary. What happened?

A, M/hen instructions conflict, the oven carries out the last instruc- tion. You may have set the oven to Defrost for 4 minutes, Hold/’Time for 2 minutes, and then Defrost for 6 minutes. In this case, the oven would Defrost for 6 minutes and Hold/Time for 2 minutes,

11