GE JKP90BMBB dimensions JKP90BM/CM/WM, GE 27 Built-In Double Microwave/Thermal Wall Oven

JKP90BM/CM/WM

GE® 27" Built-In Double Microwave/Thermal Wall Oven

Dimensions and Installation Information (in inches)

KW Rating

240V	6.4
208V	4.8
Breaker Size
240V	30 Amps
208V	30 Amps

Note: Cabinets installed adjacent to wall ovens must have an adhesion spec of at least a 194°F temperature rating.

Note: if marks, blemishes or the cutout opening is visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or openings are covered.

Note: Door handle protrudes 3" from door face. Cabinets and drawers on adjacent 45° and 90° walls should be placed to avoid interference with the handle.

Electric wall ovens are not approved for installation with a plug and receptacle. They must be hard wired in accordance with installation instructions.

Installation Information: Before installing, consult

installation instructions packed with product for ­current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

10

L		Recommended
		junction box
C	2 x 4 or	locations.
	equivalent	Locate junction
	runners
		box either 5" MIN.
		below cutout
		floor or 48" MIN.
		above cutout
		floor

Suitable						D
bracing	18"
to support
		over centerline
runners
		of cabinet			Access
(must support 275 lbs.)
					from
					adjacent
					cabinet
					required
Cabinet			27"
A – Cabinet width required				27" min.
B – Minimum cabinet depth			23-5/8"		Minimum	E
C – Opening width			25" min. - 25-1/4" max		cutout location
D – Opening height				41-1/4" max	from floor
E – Minimum cutout location from floor			22"
Oven
F – Overall depth*			23-5/8"
G – Overall height with trim			43" - 43-7/8"
Overall height without trim			42-1/8"
H – Overall width			26-5/8"

*Depth including door handle is approximately 26-7/10" min. to 26-8/10" max.

A

Allow 3/4" for overlap of oven over all

edges of cutout

C

2" X 4" or

Bequiv. runners H

G

21

Conduit (48-1/2"

long) F

Allow minimum of 21" for clearance to adjacent corners, drawers, walls, etc.

All GE ranges are equipped with	Listed by
an Anti-Tip device. The installation
of this device is an important,	Underwriters
required step in the installation	Laboratories
of the range.

Specification Created 1/07 320374