GE 27 Built-In Single Wall Oven, Cabinet

JKP30SM

GE® 27" Built-In Single Wall Oven

Dimensions and Installation Information (in inches)

KW Rating

240V	3.4

208V	2.6

Breaker Size

240V	20 Amps

208V	20 Amps

Note: These ovens are not approved for stackable or side-by-side installations.

Note: Cabinets installed adjacent to wall ovens must have an adhesion spec of at least a 194°F temperature rating.

Note: For 27" built-in single ovens, if marks, blemishes or the cutout opening is visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or openings are covered.

Note: Door handle protrudes 3" from door face. Cabinets and drawers on adjacent 45° and 90° walls should be placed to avoid interference with the handle.

Electric wall ovens are not approved for installation with a plug and receptacle. They must be hard wired in accordance with installation instructions.

Locate junction box either 5" MIN. below cutout floor or 44" MIN. above cutout floor

Access from

adjacent D cabinet required

Minimum

cutout location 32-1/2 from floor

(Minimum 15-5/8"
from floor when	2" x 4"
installed below built-in	or equiv.
microwave oven)	runners

2" x 4" or equivalent runners

A	Allow 3/4"
	Allow 3/4"
	for overlap
	over all edges
	of cutout

B MIN.

C MIN.

Conduit 48-1/2" long

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

Suitable bracing to support runners

18"

Over centerline

of cabinet

(must support 275 lbs.)

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Cabinet		27"
	A – Cabinet width required	27" min.
	B – Minimum cabinet depth	23-5/8"
	C – Opening width	25" min. - 25-1/4" max
	D – Opening height	27-5/8" min. - 28-1/8" max.
	Oven
	E – Overall depth*	23-5/8"
	F – Overall height with trim	29-7/8" - 30-3/4"
	Overall height without trim	29"
	G – Overall width	26-5/8"

*Depth including door handle is approximately 26-7/10" min. to 26-8/10" max.

All GE ranges are equipped with an Anti-Tip device. The installation of this device is an important, required step in the installation of the range.

Listed by Underwriters Laboratories

Specification Revised 10/07

320444