GE PNSF39Z01 Typical Installation Illustration, Optional 3-Valve Bypass Installation Illustration

Installation instructions.

Typical Installation Illustration

Fig. 1

MAIN WATER PIPE

Soft water

Hard water

120-volt outlet

24V transformer

			Hard water to
			outside faucets
		Union (2) (not supplied)
		Nut (2)
		Copper tube, 3/4″ (2)
		Washer (2)
		Bypass Valve
		• pull out for service
		• push in for bypass
	INLET	NOTE: Threads on the
		bypass valve are 1” male
		pipe. If 1” pipes are
		needed, do not use the
		copper tubes and nuts
		included. Buy 1” pipe
		thread female adapter
Brinewell
		and plumb directly to 1”
		threads.

NOTE: See Drain Hose

Connections section.

CROSS-OVER

Use if water supply flows from the left.

Include single or 3-valve bypass.

Hard water

Soft water

To softener inlet

From softener outlet

Optional 3-Valve Bypass Installation Illustration

Adapters for this installation are not supplied with the softener.

To order these adapters, call GE Parts 800-626-2000. Ask for part number WS60X10006.

Fig. 2

Bypass valve

Hard water to outside faucets

Soft water

	Outlet valve
120-volt outlet

24V transformer

MAIN
WATER
PIPE	Hard water

Inlet valve

3-valve bypass system For soft water service:

• Open the inlet and outlet valves

• Close the bypass valve For bypass hard water:

• Close the inlet and outlet valves

• Open the bypass valve

Nut (2)

Copper tube, 3/4″ (2)

Washer (2)

Installation adapter (2) (see above)

INLET

Hard water

Soft water

To softener inlet

From softener outlet

CROSS-OVER

Use if water supply flows from the left.

Include single or 3-valve bypass.

6

Note: Threads on the installation adapters are 1″ male pipe. If 1″ pipes are needed, do not use the copper tubes and nuts included. Buy 1” pipe thread female adapter and plumb directly to 1” threads on installation adapters.