Maintenance
Oven Light Replacement
CARE
WARNING
CAUTION
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns.
AND
1.Disconnect power at the main fuse or circuit breaker panel.
2.Remove oven racks.
3.Slide a flat blade screwdriver between the housing and the glass light cover.
4.Support the glass light cover with two fingers to prevent the cover from falling to the bottom of the oven. Be careful not to chip the oven coating.
5.Gently twist the screwdriver blade to loosen the glass light cover.
6.Remove the glass light cover.
7.Remove the bulb by firmly grasping and sliding the bulb straight out until the two prongs have cleared the ceramic holder.
8.Do not touch the glass of the new replacement bulb with your fingers. It will cause the bulb to fail when it lights. Grasp the replacement bulb with a clean towel or facial tissue with the prongs facing down. Align the two prongs in the ceramic holder, pressing gently until the bulb is securely in the ceramic socket.
9.Slide the protective lens into the holder and push until the clips snap into the housing.
10.Reconnect power.
CLEANING
Lift-Off Oven Door
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1.Fully open the door.
2.Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat- blade screwdriver, may be required.
3.Firmly grasp both sides of the door at the top.
4.Close door to the door removal position. The door should be open approximately 3" with no obstruction above the door.
Slot
Hinge lock
5.Lift door up and out until both hinge arms are clear of the slots.
To replace the door:
1.Firmly grasp both sides of the door at the top.
2.Starting on the left side, with the door at the same angle as the removal position, seat the indentation of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Repeat for right side.
3.Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.
4.Push the hinge locks up against the front frame of the oven cavity, to the locked position.
5.Close the oven door.
Pull hinge locks down to unlock
Hinge arm
Hinge lock
Push hinge locks up to lock
Removal position
Bottom | Hinge arm |
edge of |
|
slot |
|
| Indentation |
| 19 |