Palm Handheld Installation and Operation

To interface with a Spectra dome drive or IPS-RDPE-2 remote data port using a Palm handheld, first install the Control/Upload Utility and then install the IPS-CABLE.

The Control/Upload Utility is compatible with Palm OS version 3.5 or higher.

NOTE: Know how to operate a Palm OS-compatible handheld before attempting to control or upload software using the IPS-CABLE.

INSTALL THE CONTROL UTILITY FOR A PALM OS-COMPATIBLE HANDHELD

1. Insert the Resource CD into the CD drive. The main menu appears on the monitor.

NOTE: If autoplay is not enabled on your system, you need to navigate to the CD drive and select Start to open the main menu.

2.Click the Control/Upload Utility button for Spectra, Esprit, or ExSite. The File Download box appears on the monitor. Open or save the Control/Upload Utiltiy file to the PC.

3.Use the HotSync® function to install the application software onto the Palm OS-compatible handheld. Refer to the manual supplied with the Palm OS-compatible handheld for instructions on how to perform a HotSync operation.

INSTALL THE CABLE

To install the IPS-CABLE, refer to Figure 2 and do the following:

1.Connect a Palm OS-compatible serial cable (not supplied) to the handheld serial port.

2.Connect the 9-pin male connector from the IPS-CABLE to the Palm OS compatible serial cable.

3.Connect the IPS-CABLE to the RJ-45 port of the Spectra dome drive or IPS-RDPE-2.

NOTE: When connected, the IPS-CABLE will interrupt control from the normal control source.

10	C2458M-E (10/06)