GE 164D3333P235 owner manual Safety Precautions

Page 4

IMPORTANT SAFETY INSTRUCTIONS

WARNING!

For your safety, the information in this manual must be followed to minimize the risk of fire, electric shock, or to prevent property damage, personal injury, or loss of life.

SAFETY PRECAUTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:

• Be sure your appliance is properly installed and grounded by a qualified installer in accordance with the provided installation instructions.

• Have the installer show you the location of the circuit breaker or fuse. Mark it for easy

 

reference.

 

• Use this appliance only for its intended use

 

as described in this manual.

 

• Do not attempt to repair or replace any

 

part of your cooktop unless it is specifically

 

recommended in this manual. All other

 

servicing should be referred to a qualified

 

technician.

 

• Before performing any service, DISCONNECT

 

THE COOKTOP POWER SUPPLY AT THE

 

HOUSEHOLD DISTRIBUTION PANEL BY

 

REMOVING THE FUSE OR SWITCHING

 

OFF THE CIRCUIT BREAKER.

 

• Do not leave children alone—children should

 

not be left alone or unattended in an area

 

where an appliance is in use. They should

 

never be allowed to sit or stand on any part

 

of the appliance.

 

• Do not allow anyone to climb, stand or hang

 

on the cooktop.

 

• CAUTION: ITEMS OF INTEREST

 

TO CHILDREN SHOULD NOT BE STORED

 

IN CABINETS ABOVE A COOKTOP—

 

CHILDREN CLIMBING ON THE COOKTOP

 

TO REACH ITEMS COULD BE SERIOUSLY

 

INJURED.

 

• Never wear loose-fitting or hanging garments

 

while using the appliance. Be careful when

 

reaching for items stored in cabinets over the

 

cooktop. Flammable material could be ignited

4

if brought in contact with hot surface unit and

may cause severe burns.

 

•Use only dry pot holders—moist or damp pot holders on hot surfaces may result in burns from steam. Do not let pot holders touch hot surface unit. Do not use a towel or other bulky cloth in place of a pot holder. Such cloths can catch fire on a hot surface unit.

•For your safety, never use your appliance for warming or heating the room.

•Do not store flammable materials near the cooktop.

•Keep the hood and grease filters clean to maintain good venting and to avoid grease fires.

•Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

•Do not let cooking grease or other flammable materials accumulate on the cooktop.

•Do not use water on grease fires. Never pick up a flaming pan. Turn the controls off. Smother a flaming pan on surface unit by covering the pan completely with a well-fitting lid, cookie sheet or flat tray. Use a multi-purpose dry chemical or foam-type fire extinguisher.

•Flaming grease outside a pan can be put out by covering it with baking soda or, if available, by using a multi-purpose dry chemical or foam- type fire extinguisher.

•Clean the cooktop with caution. If a wet sponge or cloth is used to wipe spills on a hot surface unit, be careful to avoid steam burns. Some cleansers can produce noxious fumes if applied to a hot surface.

•NOTE: We recommend that you avoid wiping any surface unit areas until they have cooled and the indicator light has gone off. Sugar spills are the exception to this. Please see the Glass Cooktop Cleaning section.

•When the cooktop is cool, use only the recommended cleaning cream to clean the cooktop.

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Radiant Cooktop Introduction ContentsRemove packaging tape Before using your cooktop If you need serviceWrite down the model Serial numbers If you received a damaged cooktop Save time & moneySafety Precautions Safety Precautions Safety Precautions Features of Your Cooktop Design informationHow to set the controls Radiant surface units Do not use the surface as a cutting boardUsing the bridge surface unit Using the dual surface unit Turn the control knob to the desired settingRight front surface unit has 2 cooking sizes to select From so you can match the size of the unit to the sizeTypes of cookware RecommendedStoneware usable, but not recommended Glass-ceramicusable, but not recommendedWhat is a temperature limiter? Observe the following points in canningControl knobs Daily cleaning Glass Cooktop Cleaning For heavy, burned-on soil…Special care for sugary spills Before You Call For Service… Save time and moneyRegistration Ownership Product Consumer Consumer Product Ownership Registration In-Home Repair Service Service Contracts 800 Parts AccessoriesGE Answer Center 800.626.2000 For Customers With Special Needs… 800.626.2000Warranty Replacement radiant surface unit if it should burn out

164D3333P235 specifications

GE 164D3333P235 is a sophisticated and robust component designed for specific applications in industrial and commercial sectors. This component is part of General Electric’s extensive portfolio of high-performance systems and accessories. It showcases innovative technologies and engineering excellence synonymous with the GE brand.

One of the main features of the GE 164D3333P235 is its exceptional reliability. It is engineered to endure demanding operating environments, making it suitable for industries that require consistent performance under various conditions. The construction of this unit emphasizes durability, ensuring a long life span that minimizes the need for frequent replacements or repairs.

The GE 164D3333P235 is equipped with state-of-the-art technology that enhances its functionality. It often includes advanced electronic controls that streamline operations and improve energy efficiency, which is critical in today's energy-conscious landscape. This component is designed to support complex automation systems, allowing for seamless integration with other GE technologies and third-party systems.

Another characteristic that stands out is its versatility. The GE 164D3333P235 can be utilized in a range of applications, from manufacturing and factory automation to utilities and infrastructure management. This adaptability makes it a valuable solution for businesses looking to enhance their operational capabilities.

Safety features are also a priority in the design of the GE 164D3333P235. It typically includes built-in safeguards to protect against common electrical hazards, ensuring that users can operate the equipment with confidence. These features are crucial for compliance with industry standards and regulations.

In terms of user-friendliness, the GE 164D3333P235 often comes with comprehensive documentation and support resources, allowing operators to easily understand and utilize its capabilities. Training programs and customer support services may be available, which can further enhance the user's experience and efficiency.

In conclusion, the GE 164D3333P235 exemplifies the innovation and reliability GE is known for. With its advanced technologies, versatile applications, and robust safety features, it stands out as a crucial component for businesses looking to enhance productivity and efficiency while minimizing operational risks.
Top Page Image Contents