GE GSM2000 manual Operation of electronic models model GSD4000 Only, Start, Clean, START/RESET pad

Page 8

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

Operation of electronic models (model GSD4000 Only)

Using the Dishwasher Door

1The door must be closed and locked into place to select a LOAD SELECTION or an OPTION.

2If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the door is closed and latched into place.

Start

Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins.

NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and display the last settings you selected.

If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.

Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.

Clean

This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.

Flashing Display Lights

Lights

What It Means

What To Do

 

 

 

 

This is normal.

Allow the dishwasher to drain and reset before you start a new

 

 

The START/RESET pad

wash cycle.

START

has been pressed.

 

RESET

 

 

 

 

 

 

 

 

 

Control Error

Press the START/RESET pad to turn off the beeper. If the CLEAN

CLEAN

 

light continues to flash, call for service.

 

 

 

PLUS A

BEEPING

SOUND

Control Error

Press the START/RESET pad to turn off the beeper and the

 

dishwasher will attempt to reset. Restart the wash cycle.

 

If this error continues, turn off the power to the dishwasher at

 

the circuit breaker for 30 seconds. Try the dishwasher again.

 

If the error is still present, call for service.

PLUS A

BEEPING

SOUND

8

Image 8
Contents Dishwashers Write the model and serial numbers here Model # Serial #Proper Installation and Maintenance Before You Throw Away Your Old Dishwasher Ge.comOptions About the dishwasher control panelCycles Cycle Chart Model Cycle Water Usage gal Cycle Time minAbout the dishwasher control panel Operation of models with cycle dialge.com Rinse OnlyPlate Warmer or Drying Hot Start or Hot Prestart OptionClean START/RESET padOperation of electronic models model GSD4000 Only StartUsing the dishwasher NumberLoading the dishwasher racks Loading place settings… Upper Rack-10 place settingsUpper Rack-12 place settings Lower Rack-10 place settingsOptional accessories Air gap is easy to cleanCaring for the dishwasher Does Your Dishwasher Have an Air Gap?Before you call for service… Problem Possible Causes What To DoRemove marks with a mild, abrasive cleaner Too little detergentDetergent recommendations Acid crystals instead of vinegarGE Dishwasher Warranty One YearSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio