GE GLD5500 Option adds 20 minutes to the cycle time, Controls after you have started a cycle

			ge.com
		Options
	3
		The light above the selected pad will be ON to indicate which OPTION has been selected.
		HOT START	For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected
		(on some models)	PRIOR to starting the cycle. This option will improve both wash and dry performance. This
			option adds 20 minutes to the cycle time.
			NOTE: Cannot be selected with RINSE ONLY cycle.
		HEATED DRY	Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For faster air dry,
		Light OFF	you can prop the door open after the CLEAN light illuminates.
		HEATED DRY	Turns the heater on for fast drying. This will extend the total run time by 38 minutes.
		Light ON	NOTE: Cannot be selected with RINSE ONLY cycle.
		LOCK	You can lock the controls to prevent any selections from being made. Or you can lock the
			controls after you have started a cycle.
			Children cannot accidentally start dishwasher by touching pads with this option
			selected.
			To LOCK the dishwasher control, touch and hold the HEATED DRY pad for 3 seconds. The light below the
			HEATED DRY pad will turn on. To UNLOCK the dishwasher control, touch and hold the HEATED DRY pad for
			3 seconds. The LOCK light will turn off.
		HOT WASH	When selected, the cycle will run longer with the heating element on to improve both wash and
			dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
		DELAY HOURS	You can delay the start of a wash cycle for up to 8 hours. Touch the DELAY HOURS
			pad to choose the number of hours you want to delay the start of the cycle; then touch
			START/RESET one time. The dishwasher will count down and start automatically at the correct
			time. Touching START/RESET a second time will cancel the DELAY START selection.
		RESET	To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle.
			The START/RESET light will flash while the water is pumped out if needed. This takes
			approximately 90 seconds. When the light stops flashing, the dishwasher can be
			reprogrammed and restarted.
4		Start

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60 seconds later the wash action begins. Touching the START/RESET pad a second time will cancel the cycle and cause the water to drain out. This will take approximately 2 minutes.

NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.

If you don’t want to change any of the settings, simply touch the START/RESET pad once to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not pressed within two minutes. To activate the display, open and close the door or touch any pad.

Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.

7

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support