GE GLDSO00 Light on, Controls after you have started a cycle, Models, Reprogrammed and restarted

_l Options

The light above the selected pad will be ON to indicate which OPTION has been selected.

HOT START

For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be

(on some

selected PRIORto starting the cycle. This option will improve both wash and dry

models)

performance. This option adds 20 minutes to the cycle time.

NOTE:Cannot be selected with RINSEONLY cycle.

HEATEDDRY

Shuts off the drying heat option. Dishes air dry naturally and energy is saved.

Light OFF

For faster air dry you can prop the door open after the CLEAN light illuminates.

HEATEDDRY

Turns the heater on for fast drying. This will extend the total run time by B8 minutes.

Light ON

NOTE: Cannot be selected with RINSE ONLY cycle.

LOCK

You can lock the controls to prevent any selections from being mode. Or you con lock

the controls after you have started a cycle.

HOT WASH

When selected, the cycle will run longer with the heating

element on to improve both

wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.

DELAY HOURS

You can delay the start of a wash cycle for 2, 4 or 8 hours

{delay time options may

vary by model). Touch the DELAY HOURS pad to choose the number of hours you want

to delay the start of the cycle; then touch START/RESET one time. The dishwasher will

count down and start automatically at the correct time. Touching START/RESETa

second time will cancel the DELAY START selection.

RESET

To change a cycle offer washing starts, touch the START/RESETpod to cancel the

cycle. The START/RESETlight will flash while the water is pumped out if needed. This

tokes approximately 90 seconds. When the light stops flashing, the dishwasher can be

reprogrammed and restarted.