Installation Recommendations
Install the Fan - Continued
3.Installation of ductwork is critical to the performance of the fan, shown in Fig. 11. Straight ductwork (1) or ductwork that turns in the same direction as the wheel (2) is recommended. Ductwork turning opposite the wheel direction (3) will cause turbulence and back pressure resulting in poor performance.
4.Slide ductwork over the fan’s discharge collar and securely attach it with sheet metal screws. Make sure the screws do not interfere with damper operation. Check damper to make sure it opens freely.
1 (GOOD)
2 (GOOD)
AIR FLOW
Fig. 11
3
(POOR)
Wire the Fan
1.Remove wiring cover. Then wire unit to the correct installation type, shown in Fig. 12, using proper wire connectors.
Black wire is “Hot”
White wire is “Neutral”
Green wire is “Ground”
Fig. 12
2. Push all wiring into the unit’s cover and replace wiring cover.
Attach the Grille
1.Attach grille with two screws provided, shown in Fig. 13. Make sure not to over tighten, over tightening will damage grille.
2.Turn on power and check fan operation.
Fig. 13
3