Installation instructions |
|
5 | |
|
Mounting to cabinetry sides
Fix rangehood to your wall units, with 2 screws in each side into the vertical panels. To do this:
1Slide out the drawer and remove filter. You will see two mounting holes running through the moulded sides (see Fig.7).
2Remove the thin plastic skin (A) from each side fixing hole. An 8 mm diameter drill bit is recommended.
3Position slideout (ensuring unit is level) and fix in place using screws and hollow dowels through each side fixing hole (see Fig.8). (Check screw length with thickness of cabinet panels).
The rangehood’s plug can be easily plugged into the nearest wall socket, or if connected directly into the house wiring, a registered electrician is required.
Fig.7 Fixing holes
Hollow Dowel
Cupboard
Slideout Slide