Fisher & Paykel RB905, RB365 dimensions Move Product Into Cavity FIT Drawer Panel Attachment Hooks

11MOVE PRODUCT INTO CAVITY

12FIT DRAWER PANEL ATTACHMENT HOOKS

1 /”

(46 mm)

3

2

Important!

Be careful not to damage power supply cord when pushing product into cavity.

Important!

Do not screw in trim brackets at this stage.

1

1

2

1		(35 ½” [902 mm])
	12 ¼” (311 mm) 12 ¼“ (311 mm)			”
				/
				16
				(414 mm)
	/”		9 mm	X
			X = 7 /” (194mm) - C,
(18 mm)
			where C is bottom face
			of panel to top of spacer
			block, see 6

/“

(2.5 mm)

Attach handle as necessary. Ensure all screws are flush with panel surface.

2

x 3 /” (5 mm)

					”
				/
/		-	
				mm)
(16	- 20

/” (1 mm)

13ATTACH DRAWER PANEL TO FRONT OF DRAWER

1 2 3 4 5

Hook drawer panel onto drawer front channel

Open drawer and

Close the drawer and check vertical clearances

6

Replace panel on

drawer and confirm

vertical clearances

Remove the panel and adjust the TOP attachment hooks

as necesary

7 8

Slide panel to achieve even horizontal clearances

clamp panel onto drawer by tightening the BOTTOM attachment hook

Close the drawer and ensure it is flush	Ensure there is clearance
with adjacent cabinetry. If not, the	between panel and cabinetry
product may have to be pulled back	when drawer is fully closed
or forward.