GE ZISW360DX dimensions Framed Panel Dimensions, Dispenser Models, Important Note

ZISW/B360DX

GE Monogram® 36" Built-In Side-by-Side Refrigerator with Dispenser and Water Filter

Dimensions and Installation Information (in inches)

1/4" Framed Panel
Dimensions					5/16"
If you choose to install framed
	Door				Trim
panels, they must be cut to the			Revea
dimensions shown. The panels will
slide into the frame on the door and
grille.		1/4"
If the custom panel is less than 1/4"				Panel
thick, and it fits loosely in the door
frame, it can be backed up with a
piece of filler material or foam tape
to improve the fit.

Important Note:

Maximum total panel weight:

•Fresh food door panel – 75 lbs.

•Freezer door panel – 52 lbs.

•Grille panel – 18 lbs.

						33-7/8"
					Grille Panel
									9"
Dispenser Cutout
				17-			13/16
			Dispenser
			Cutout
		15-3/8"
			3-1/8"						68-3/8"
	9-5/8"		Freezer					Fresh
				Panel				Food
				14-9/16"				18-9/16"

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Dispenser Models

These refrigerators are supplied with two dispenser trims, one for framed panels and one for overlay panels.

1/4" Framed Panel

The framed panel must be 1/4" nominal thickness to fit the dispenser trim.

•The dispenser trim fits over the custom panel and snaps into the freezer door.

•If the panel is less than 0.250" thick, a noticeable gap may be created around the dispenser trim. Foam tape may be applied on the door to improve the fit.

•If the panel is more than 0.250" thick, the dispenser trim cannot be secured to the door.

1/4" FREEZER DOOR 0.250"

Framed	Thick
Panel
	Ice / Water Dispenser

1/4" Dispenser Trim

3/4" Overlay Panels

The overlay dispenser trim is designed to fit a total panel thickness of 1.100".

•If the panel is less than 1.100" thick, a noticeable gap may be created around the dispenser trim.

•If the panel is more than 1.100" thick, the dispenser trim cannot be secured to the door.

•The overlay panel must be constructed according to the specifications shown to achieve the correct total thickness.

•Alternative panel construction methods such as securing a 3/4" panel to a 1/4" backer panel cannot be used. Another method, routing a 3/4"-thick panel on all sides, cannot be used. These methods will not result in the required 1.100" panel thickness.

•When a raised panel design is to be used, a custom middle rail is required.

1/4" Backer Panel	FREEZER DOOR	1.100"
.10" Spacer		Total
		Thickness
Panel

	Ice / Water Dispenser
3/4" Overlay
Panel	3/4" Overlay Dispenser Trim

Listed by	As an Energy Star®
	partner, GE has determined
Underwriters
	that this product meets the
Laboratories
	Energy Star guidelines
	for energy efficiency.

Specification Created 3/08 110109