INSTALLATION OPTIONS
INSTALLATION ABOve A WALL OveN Or WArMING DrAWer
Thermador Masterpiece® Gas Cooktops may be installed above a Thermador Single
Thermador Masterpiece Gas Cooktops may also be installed above a Thermador Warming Drawer to create a convenient cooking center. Refer to the warming drawer section for additional specifications.
IMPOrTANT
We strongly recommend the installation of a Thermador Ventilation System with this gas cooktop.
Seal the surfaces of the cutout to make them heat resistant. This prevents the surfaces from expanding as a result of humidity.
Solid surface countertops require a special cutout size and special installation. For example, heat reflective tape or rounded corners may be necessary. Contact the countertop manufacturer for instructions specific
to your countertop.
NATUrAL GAS Or LP
Thermador Masterpiece Gas Cooktops are shipped by the factory to operate on natural gas. They must be converted for use with propane. Verify the type of gas being used at the installation site matches the type of gas used by the appliance. If the location/job site requires conversion from natural gas to propane (Lp), order SNLpkITF. Field conversion must be done by qualified service personnel only. please refer to the Lp Conversion Instructions for further information.
INSTALLATION ABOVE A THERMADOR BUILT-IN OVEN
GAS COOKTOPS 30-INCh
Models: SGS305FS, SGSX305FS
CABINET REQUIREMENTS
Dimension requirements are for combustible surfaces. When the surface is protected by a material listed by UL as a Floor protector and Wall Shield covered with not less than No. 28 MSG sheet metal 0.015 inch (0.38mm) stainless steel, 0.024 inch (0.6mm) aluminum or copper, it is considered noncombustible and some dimensions may be reduced. For a noncombustible surface over the cooktop, the minimum clearance is 24" (61cm) rather than 30" (76cm).
COOKTOPS — GAS
| 511/16" | 313/16" | 43/16" |
|
| (144mm) | (97mm) | (106mm) | COUNTERTOP |
|
|
|
| |
63/4" | COOKTOP |
| 3"(76mm) | |
(172mm) |
|
|
|
|
Gas | SUMP |
|
| |
Connection |
| 3/8" |
|
|
|
|
|
| |
| 11/8" | (9mm) |
|
|
|
|
|
| |
36" | (28mm) | OVEN | 281/4" |
|
|
| |||
(914mm) | 247/16" |
| (718mm) |
|
|
|
|
| |
| (621mm) | 1 |
| 291/16" |
|
| 27 /16" | (738mm) | |
|
| (687mm) | ||
|
|
| ||
43/4" |
|
|
|
|
18" (46cm) min.
Left Side
12" (30cm) min.
Depth from Back Wall
Cabinet 13" (33cm) max.
Hood Depth - 24" (61cm) max.
Above Counter - 30" (76 cm) min. to
Combustible Surface
SGS(X)30 - 30" (76cm) min. SGS(X)36 - 36" (91cm) min.
Centered Over Cooktop
Rear Wall -
Right Side
12" (30cm) min.
TOE KICK |
(121mm) |
Note: Dimensions based on standard countertop height (36" with 43/4" toe kick including base plate).
The
WARNING: To reduce the risk of ignition of nearby combustible materials, install the countertop with a minimum distance of 12" (30cm) from side walls and 1 3/4" (4cm) from back wall.)
NOTE: All measurements given have to be precisely followed. If nonstandard cabinets are used, make sure they are installed with minimum dimensions shown.
plan the installation of the unit so that the power cord, gas
1.800.735.4328 THERMADOR.COM | 117 |
|