6.2.2 Country
This function provides for automatic adjustment for summer and winter time. Using the arrow keys right/left, enter your home country in the line Country.
>Press the Back key to return to the menu Settings, or press the Menu key to return to normal operation. The settings are automatically stored in memory.
6.2.3 Remote control code
Your digital receiver can be operated wither with the remote control unit supplied (remote control code Sat2), or with an optional remote control unit utilising remote control code Sat1. This option allows you, for instance, to operate two similar sets in the same room, with each being controlled independ- ently, and without interference of the other. To do this, unit 1 is controlled by remote control code Sat1, and unit 2 by remo- te control code Sat2.
In this line, decide whether your receiver should be allocated the remote control code SAT1 or SAT2.
>In this line, operate any key of the appropriate remote control unit (Sat1 or Sat2) to select the remote control code.
>Press Back to return to the menu Settings, or press Menu to return to normal operation. The settings will be stored automatically.
6.2.4 Antenna feed 5V
If you are using an active antenna, you will have to switch on
the antenna power feed (5V/30mA). The antenna will be fed via the terrestrial antenna input.
>In this line, use the arrow keys left/right to switch the antenna feed on or off.
In case of an overload or short circuit of the antenna feed, this will be switched off automatically. If this occurs, rectify the problem/cause, then switch the antenna feed on again.
6.2.5 Stand-by clock*
To reduce the power consumption of your unit in
>In this line, use the arrow keys left/right to set the standby clock mode to on or off.
>Press Back to return to the menu Settings, or press Menu to return to normal operation. The settings will be stored automatically.
16 | *valid only for DigiPal 2 |
|