GE ZDBC240 Condenser Cabinet Interior Glass door Door gasket, In the event of a power failure

Condenser

Cabinet

Interior

Glass door

Door gasket

Light bulb replacement

In the event of a power failure

Care and Cleaning

Beverage Center

Unplug the beverage center before cleaning.

Be sure that nothing obstructs the	Screws
required air flow openings in the front
of the cabinet. For best performance,
brush or vacuum lint and dirt from the
condenser once a year.
Remove the cover from the bottom rear of
the beverage center to access the
condenser. Remove the three screws from
the top of the cover and bend the sides of
the cover slightly inward to release the tabs
on each side of the cover.
When replacing, feed the power cord	Tabs
through the hole on the bottom left of
the cover.
The painted cabinet can be washed with
mild soap and water. Rinse thoroughly
with clear water. Never use abrasive
scouring powders.
Wash the inside with mild soap and water	Do not use an abrasive powder, solvent,
or baking soda and water.	polish cleaner or undiluted detergent.
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door.
Do not use any abrasive powders.
The vinyl gasket may be cleaned with mild	After cleaning the door gasket, apply a
soap and water, a baking soda solution or	thin layer of paraffin wax or petroleum
a mild scouring powder. Rinse well.	jelly to the door gasket at the hinge side.
	This helps keep the gasket from sticking
	and bending out of shape.
Unplug the beverage center before	To remove the light shield, push in the tab
replacing the light bulb.	on the left side of the shield and lower it.
	Replace with a 15 watt appliance bulb.
If the power fails, open the door as	Do not store or use gasoline or other
infrequently as possible to maintain	flammable vapors and liquids in the
the temperature.	vicinity of this or any other appliance.

11