GE TBXK17 manual ~earanees, To adjustrollersor Ieveling!egsq

Because of potential Saiety haz:trdsLInciercertain conditions, we str{)nglyrticommend against LISe of an ac~aptcrplug. However, it’you still elect to use an adapter, where local codes permit, a ~EMPORARY CONNECTIONmaybe madeto a

properlygroundedtwo-prongwall- outlet byuseof a ULlistedadapter

(Fig.2) availableat mostlocal hardwarestores.

TEMPORARY METHOD .-,

(&DAPTER PLUGS NOT PERMITTED IN CANADA)

ALIGN LARGE

-; INSURE PROPER GROUND

Fig, 2

The larger slot in the adapter mustbe alignedwiththe largerslot in the walloutlet to provideproper poIarityin the connectionof the powercord.

CAUTlON: Attaching adapter ground terminal to walloutlet

cover screw does not ground the appIianceunlesscover screw is metal. and not insulated,and wall outlet is grounded through house wiring.YoushouIdhave the circuit checked by a qualifiedelectrician

to make sure the outlet is properly grounded,

When tiscomecting the power cord fromthe adapterqalwayshold the adapter with one hand. If this is not done, the adapter ground terminalis very likelyto break with repeated use.

Becauseof potential safety hazards under certain conditions, we strongly recommend against the use of all extension cord. However, if you stilI elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wiregrounding type appliance extension cord havi-

c~earanees

Alow the following clearances for ease 01 installationand proper air Circdation:

sides____ -----3/4°

Top----- ___----l”

Back----__ -----l”

water supply to Ieemaker

(onmodels so equipped)

You willneed to connect your icernaker to a cold water line, A water supplykit containingcopper tubing, shut-off valve,fittingsand instructions is availableat extra cost from your dealer.

men building a new home...

consider providingwater supply to refrigerator jocation.It wil~simplify connection of’an optional auto- matic icernaker should youwishto install one later.

To adjustrollersor Ieveling!egsq

remove base grilleby graspingit at bottom and pullingit out.

I	ROLLER	II	I
	~	r LEVELINGLEG

Turn roller adjustingscrewsor levelinglegseEockTtiseto raise refrigerator,countercloclttise to lower it. Use adjustablewrench or p~ierson the roller adjusting screw’s3/8” hex head bolt.

When adjustingrollers or leveling legs for proper door closure, bot- tom front edge of cabinet should be approximately3/4” from floor.

To replace base gri]ie~align prongs on back of grille with clamps in cabinet and push forward until gril~esnaps into p}ace.

4