PSB48YGX
GE Profile™ 48"
The Installation Space
|
|
|
|
| 3" |
| |||||||||
| *Finished Width |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7" | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7" |
|
|
|
|
|
|
| |||
84 1/2" max | Electrical |
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| ||||
Dimensions and Installation Information Grounding the Refrigerator
for personal safety, this appliance must be properly grounded.
The power supply cord of this appliance is equipped with a
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
Where a standard
do not, under any circumstances, cut or remove the third
Side Panels
Side panels (not supplied) must be used whenever the sides of the refrigerator will be exposed.
*Depending on installation height.
Flooring
*84"
24"
*3" to 4" 
83 1/2" min | Area | |
74" | ||
Finished | ||
Opening | From Floor | |
24" | to Bottom | |
of Electrical |
5" 
Water Supply 
5" 3 1/2"
3 1/2"
*The finished cutout width must be:
Water and Electrical Locations
The opening must be prepared with the electrical and water supply located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond adjacent cabinets, depending on your installation.
Additional Specifications
• A 120 volt, 60Hz, 15 or 20 amp power supply is required. |
An individual properly grounded branch circuit or circuit |
breaker is recommended. Install a properly grounded 3- |
prong electrical receptacle recessed into the back wall. |
Electrical must be located on rear wall as shown. |
(ground) prong from the power cord.
do not use an adapter plug to connect the refrigerator to a
do not use an extension cord with this appliance.
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.
For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 1500 lbs.
NOTE: Protect the finish of the flooring. Cut a large section of the cardboard carton and place under the refrigerator where you are working.
Note: GFI (ground fault interrupter) is not recommended. |
• Water line can enter the opening through the floor or |
rear wall. The water line installed should be 1/4" O.D. |
copper tubing or GE SmartConnect™ tubing between |
the cold water line and water connection location. The |
line should be long enough to extend to the front of the |
refrigerator. Installation of an easily accessible shutoff |
valve in the water line is required. |
Total volume and shelf | Listed by | |
area are calculated by | ||
Underwriters | ||
the Association of Home | ||
Laboratories | ||
Appliance Manufacturers’ | ||
| ||
standards. |
|
Specification Revised 6/09 | 210379 |