Clock/Timer
English
Setting the clock
1In standby mode or system on, press and hold DISPLAY/CLOCK on the remote control for more than 3 seconds.
➜SET CLOCK scrolls on the display.
➜The clock digits for the hours flash.
2Press VOLUME (3 / 4)
3Press DISPLAY/CLOCK again.
➜ The clock digits for the minutes flash.
4Press VOLUME (3 / 4)
5Press DISPLAY/CLOCK to confirm the time.
Note:
– The backlight for clock display is dim in standby.
Viewing the clock
●Press DISPLAY/CLOCK.
➜ The clock time is displayed.
Note:
– There is no time display during disc playback.
1In standby mode or system on, press and hold TIMER on the remote control for more than 3 seconds.
➜Display sequence scrolls SET TIMER and
SELECT SOURCE.
➜Display sequence shows CD, TUNER and 
flashes.
2Press VOLUME (3 / 4)
3Press TIMER to confirm your desired mode. ➜ The clock digits for the hours flash.
4Press VOLUME (3 / 4)
5Press TIMER again.
➜ The clock digits for the minutes flash.
6Press VOLUME (3 / 4)
7Press TIMER to confirm the time. ➜ Display sequence shows VOL12.
8Press VOLUME (3 / 4)
9Press TIMER to confirm.
➜ The timer is now set and activated.
Activating and deactivating
TIMER
●Press TIMER on the remote to turn off the timer or turn on to the last setting again.
➜If activated, the timer information will display for a few seconds, then the system resumes to the last active source or stays in standby mode.
➜If deactivated,“OFF” appears.
Note:
–The system will exit timer setting mode if no button is pressed within 30 seconds.
Setting the timer
●The system can be used as an alarm clock, whereby the CD,TUNER is switched on at a set time.The clock time needs to be set first before the timer can be used.
●During setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
18