4. Connect the dispenser door tube ( 5 | 4 |
) and then insert a clip on the coupler |
|
with pulling tube. |
|
Connect the connector ( 4 ) on the left |
|
side door and one connector ( 3 ) on |
|
the right side door. | 3 |
The clip is enveloped inside of the top cap.
5
| dispenser door tube |
The dispenser door tube ( 5 ) must be fully inserted to the marked line to | coupler |
caution prevent water leakage from the dispenser. |
|
5.Position the top table ( 2 ) in place. Insert and tighten the 3 screws into the top table with a philips screw driver(+). After door opened, reinsert the cap top table ( 1 ) and close the doors.
When reattaching the top table, make sure that the wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see whether the door has gaps between gaskets or is tilted.
If you see one of them, please refer to “Adjusting the doors” on page 18.
2
1
14_ setting up