Setting up your French Door Refrigerator
4. Remove the filter cap and insert the filter into the filter | 4 | Cover filter. 5 |
housing. |
|
|
5. Slowly turn the water filter 90º clockwise to align with the printing mark on the cover, locking the filter in position. Make sure to align the water filter label mark with center of cover filter printing as illustrated. Remember, do not over- tighten.
Separation of red cap.
Turn until the label is aligned.
You should remove the right side upper glass shelf before installing the water filter.
Removing any residual matter inside the water supply line after installing the water filter.
1.Turn ON the main water supply & turn OFF the valve to the water supply line.
2.Run water through the dispenser until the water runs clear (approx. 6- 7minutes). This will clean the water supply system and remove air from the lines.
3.Additional flushing may be required in some households.
4.Open the Refrigerator door and make sure there are no water leaks coming from the water filter.
Be sure to flush the dispenser thoroughly or water may drip from it.
This is due to the fact that there is still air in the line.
20_ Setting Up