USING THE ICE MAKER
To Remove the Ice Bucket
-Hold the handle as shown in figure1.
-Slightly pull up the bottom part.
-Take out the ice bucket slowly.
To Refit The Ice Bucket
-Assemble it in the reverse order of disassembly.
-Push the bucket in firmly until you hear a clicking sound.
-When the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in figure 2.
Normal Operation
-Any sounds you hear when the ice maker dumps ice into the bucket are part of normal operation.
-Not dispensing ice for long periods may cause ice clumps in the ice bucket. Remove the remaining ice and empty the bucket.
-When ice does not come out, Check for any ice stuck in the chute and remove it.
-The first batch of ice cubes may be small due to air in the pipe after connection, any air will be purged during normal use.
- When ICE OFF blinks on the display panel, reinsert the bucket and/or
make sure it’s installed properly.
CAUTION - When the door is open, the Ice and water dispenser do not work.
-If you close the door hard, it may cause water spilling over the ice maker.
-To prevent dropping the ice bucket, use both hands when removing it.
-To prevent injury, be sure to clean up any ice or water that may have dropped on the floor.
-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.
-Be sure not to put your hand or any object into the ice chute.
It may cause personal injury or damage mechanical parts.
28_ operating
Figure1
Figure2
Ice Chute
14. 1. 18. |
��
11:42