Thermador PH30ZS, PH36ZS, PH42ZS, PH48ZS, PH54ZS, PHI48ZS, PHI60ZS manual Maintenance, Lights

Page 7

MAINTENANCE

LIGHTS

NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not operate, be sure lights are inserted correctly before calling service.

Halogen Light Replacement

(for PH and PHI Model Wall and

Island Hoods)

• Using a flat edge from a screwdriver or equivalent tool, pry loose the lens cover as shown in Figure 5 .

• Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light made for a G-4 base. Follow package directions and do not touch new light with bare hands.

• Reinstall the light and cover.

Figure 5

HEAT LAMP REPLACEMENT

(for PH Wall Hood Models Only)

•Turn heat lamp counterclockwise to remove.

•Replace lamp with either a PAR-38 175W heat lamp or a PAR-40 250W heat lamp.

The PAR-38 175W heat lamp provides a tighter seal within the enclosure and produces the same amount of effective heat with lower energy consumption. These lamps may not be readily available at local retail outlets. The PAR-40 250W heat lamp is readily available at local retail outlets.

To order PAR-38 175 heat lamps with a credit card, phone:

•OpTechInc. 800-848-6624 or

•www.bulbs.com 888-455-2800

CAUTION

DO NOT TOUCH THE BULBS IMMEDIATELY AFTER USE. THE BULBS WILL REMAIN HOT FOR SEVERAL MINUTES. DO NOT PLACE HIGHLY FLAMMABLE MATERIAL ON WARMING SHELVES.

Figure 6

PAGE 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Read and Save These Instructions Care and USE ManualTableofcontents TE and Call the Fire Department Important Safety InstructionsControl Panel for Wall Hoods Operating the HoodControl Panel for Island Hoods Light On/Dim/Off HoodcontrolbuttonsHeat Lamp for Wall Hoods Only To Clean Hood Surface Care and CleaningTo Clean Filters and Troughs Lights MaintenanceHalogen Light Replacement Heat Lamp ReplacementFull ONE Year Warranty Thermador Hood Warranty
Top Page Image Contents