Thermador HDDW 36DS installation manual Replacing the Bulbs

Page 9

REPLACING THE BULBS

1.Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box.

When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns.

2.Remove the bulb ring with a screwdriver or similar tool.

3.Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. 20 Watt, G4 bulbholder). Caution: Plug-in bulbholder.

Take hold of the bulb with a clean cloth.

4.Re-insert the bulb ring.

5.Restore the power by inserting the mains plug or switching on the fuse.

Note: If the light does not function, check that the bulbs have been inserted correctly.

PAGE 9

Image 9
Contents Ventildowndraftation Table of Contents Cuate and Call the Fire Department Important Safety InstructionsSafety Instructions EXHAUST-AIR Mode FeaturesOperation Saturation indicator ~ Filters and MaintenanceCleaning the metal grease filters Removing and inserting the metal grease filtersCare and Cleaning Stainless steel surfacesAluminium and plastic surfaces Replacing the Bulbs Customer Services Troubleshooting GuideProblem Possible Cause Remedy Before Calling for ServiceWhat is not Covered What is CoveredWarranty Application Service Data