Philips MC-200 manual General Information, Environmental Information, Supplied accessories

Page 7

General Information

This product complies with the radio interference requirements of the European Community.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Supplied accessories

2 speaker boxes

remote control

AM loop antenna

FM wire antenna

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

Place the system on a flat, hard and stable surface.

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

7

pg 001-022/MC200/22-Eng

7

10/5/01, 4:24 PM 3140 115 28691

Image 7 Contents
200 Copyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plug3140 115 Luokan 1 laserlaite Klass 1 laseraparatIndex Contents Environmental Information Supplied accessoriesSafety Information General InformationType plate is located at the rear of the system For optimal performance, use only the original power cablePreparations Rear connectionsFM Antenna Inserting batteries into the remote controlConnecting other equipment to your system Optional connectionControls on the system and remote control Preparation procedures Switching the system onAdjusting volume and sound Power-saving automatic standbyFinding a passage within a track CD OperationSelecting a different track Playing a discErasing the programme Different play modes Shuffle and RepeatProgramming track numbers Reviewing the programmeAutomatic programming Tuning to radio stationsRadio Reception Programming radio stationsRDS Programme types Tuning to preset radio stationsSearching programme type PTY Scrolling through different RDS informationAnnouncement TA RDS News and TrafficDisarming RDS News and Traffic Announcement Tape playback Switching tape sidesReverse mode options Tape Operation / RecordingPress Timer Onoff again Recording timerClock digits for the minutes flash Activating and deactivating Clock/TimerSetting the timer Setting the clockSubject to modification SpecificationsB C MaintenanceTroubleshooting Problem SolutionTape Operation / Recording Radio ReceptionGeneral
Related manuals
Manual 22 pages 56.5 Kb