
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.
Problem | Solution | |
CD OPERATION |
| |
|
|
|
| “NO DISC” is displayed. | – Insert a disc. |
|
| – Check if the disc is inserted upside down. |
|
| – Wait until the moisture condensation at the lens |
|
| has cleared. |
|
| – Replace or clean the disc, see “Maintenance”. |
|
| – Use a finalised |
|
|
|
RADIO RECEPTION |
| |
|
|
|
| Radio reception is poor. | – If the signal is too weak, adjust the antenna or |
|
| connect an external antenna for better reception. |
|
| – Increase the distance between the Micro HiFi |
|
| System and your TV or VCR. |
E n g l i s h
GENERAL
The system does not react when buttons | – Remove and reconnect the AC power plug and | |
are pressed. |
| switch on the system again. |
|
|
|
Sound cannot be heard or is of poor | – | Adjust the volume. |
quality. | – | Disconnect the headphones. |
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
The left and right sound outputs are reversed.
– Check the speaker connections and location.
The remote control does not function | – | Select the source (CD or TUNER, for example) |
properly. |
| before pressing the function button (ÉÅ,í, |
|
| ë). |
| – Reduce the distance between the remote control | |
|
| and the system. |
| – Insert the batteries with their polarities | |
|
| (+/– signs) aligned as indicated. |
| – | Replace the batteries. |
| – Point the remote control directly toward | |
|
| IR sensor on the front of the system. |
|
|
|
The timer is not working. | – | Set the clock correctly. |
| – | Press TIMER to switch on the timer. |
The Clock/Timer setting is erased.
–Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.
19