Amana DRS246RBW, DRSE663BC Unscrew 5/16 hex head screws from top hinges, Dispensing models only

Installing Your Refrigerator

These instructions were provided to aid you in the installation of your unit. Amana cannot be responsible for improper installation.

How do I measure an opening to insure proper fit?

This refrigerator was designed to fit a 69" tall opening to allow for proper ventilation, leveling, and door adjustments.

Subflooring or floor coverings (i.e. carpet, tile, wood floors, rugs) may make your opening smaller than anticipated.

Some clearance may be gained by using the leveling procedure under How to Level Your Refrigerator.

IMPORTANT: If unit is to be installed into a recess where top of unit is completely covered, use dimensions from floor to top of hinge cap to verify proper clearance.

	A = Floor to top
	of cabinet
	(68 ¾")
AB	B = Floor to top
	of top hinge
	assembly
	(70 1/ ")
	8
	C= Back of unit
	with ¼" tilt to
	back (68 ½")

How to Transport Your Unit

Follow these tips when moving the unit to final location:

•NEVER transport unit on its side. If an upright position is not possible, lay unit on its back. Allow unit to sit upright for approximately 30 minutes prior to plugging unit in to assure oil return to the compressor. Plugging unit in immediately may cause damage to internal parts.

•Use an appliance dolly when moving unit. ALWAYS truck unit from its side– NEVER from its front or back.

•Protect outside finish of unit during transport by wrapping cabinet in blankets or inserting padding between the unit and dolly.

•Secure unit to dolly firmly with straps or bungee cords. Thread straps through handles when possible. DO NOT overtighten. Overtightening restraints may dent or damage outside finish.

How to Select the Best Location

Observe these points when choosing the final location for your unit:

•DO NOT install refrigerator near oven, radiator, or other heat source. If not possible, shield unit with cabinet material.

•DO NOT install where temperature falls below 55°F (13°C). Malfunction may occur at this temperature.

•Make sure floor is level. If floor is not level, shim rear wheels of unit with a piece of plywood or other shim material.

•Allow a minimum of 1/2" clearance along top and back of unit for proper ventilation.

•To assure proper door closure, verify that the unit is leveled with a ¼" tilt to the back.

How to Remove the Doors and Hinges

Some installations require door removal to get refrigerator to final location.

!WARNING

To avoid electrical shock which can cause severe personal injury or death, observe the following:

•Disconnect power to refrigerator before removing doors. Connect power only after replacing doors.

•Green ground wire must be attached to top hinge while performing door removal and replacement.

!CAUTION

To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.

1 Remove Toe Grille and Bottom Hinge Covers

• Open both doors 180°, or as wide as possible, to remove.

3Remove top hinge cover by removing Phillips screw.

2 Unscrew union nut to detach water tube

(dispensing models only)

4Unscrew 5/16" hex head screws from top hinges.

For dispensing models only

•DO NOT remove either green ground wire or wire connecting center screw.

4