Amana IC4 manual Introduction, Parts, Safety Instructions, Tools Required

Introduction

!CAUTION

To avoid personal injury or property damage, observe all safety instructions.

Parts

Use listed part numbers only when ordering replacement parts. Part numbers are not used in installation instructions.

Verify proper ice maker kit model, listed on wiring diagram on back of refrigerator. Read entire manual before installing kit. All necessary tools and materials must be available prior to installation. Verify all listed parts are included in kit. If parts are missing, contact source from whom kit was purchased.

•Mechanical experience is required to install kit.

•Installation can take from 3 to 6 hours depending on installer’s knowledge and skill.

•If unable to solve a problem during installation, contact an authorized Amana technician. Locate a Factory Service Center or independent authorized technician by calling 1-800-628-5782inside U.S.A. and 1-319-622- 5511 outside U.S.A. Service is at owner’s expense.

Safety Instructions

!WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before installing kit. After installing kit, reconnect power.

3

		7
		5
2
8	1	4

25

12	9
13
	11

23

246

16 17

14

20

15

18

10

22

21

19

!CAUTION

To avoid property damage, observe the following:

•Confirm water pressure to water valve is at least 20 pounds per square inch.

•Start nuts by hand to avoid cross threading. Finish tightening nuts with wrenches. Do not overtighten.

•Check carefully for water leaks prior to returning refrigerator to normal location and 24 hours after connection.

Tools Required

•3/8" electric drill (ground fault protected)

•3/8" drill bit

•1/4" hex nut driver

•1/2" open-end wrenches (2)

•Bucket

•Gloves

•Knife

•Masking tape

•Pliers

•Screwdriver

•Slip joint

•Towel

	Item	Description	Part	Quantity
			number
	1	Ice makers	D7824703	1
	2	Ice maker cover	D7820401	1
	3	Warning label	A3036901	1
	4	Ice maker arm	10901401	1
	5	Stainless steel clip	B5720301	1
	6	Water fill tube extension	A3127412	1
	7	Ice maker wire harness	D7826301	1
	N/S	Thermal fuse clip	10319801	1
	8	5/8" sheet metal screw	M0211018	3
	9	Button plug	M0311301	2
	10	Ice storage bucket	D7806201	1
	11	Stop pins	M0560005	2
	12	Sliding shelf	D7839703	1
	13	Sliding shelf decorative insert	C8986123	1
	14	Water valve	D7712603	1
	15	Water valve mounting	10496302	1
		bracket
	16	3/8" thread cutting screw	M0251015	3
	17	Water valve coupling	10244903	1
		assembly
	18	Nylon nut and sleeve	M0753001	1
	19	¼" plastic tubing	B5705321	1
	20	Anti-kink spring	A1055101	1
	21	Stainless steel insert	A3223101	1
	22	Tube clamp	M0114003	1
	23	“P” clamp	M0104101 1
	24	Plastic clip	M0104101	1
2	25	Installation and operating	10527025	1
		instructions