Philips M298 Clock/Timer, Clock setting, Timer setting, To exit without storing the setting

Clock/Timer

English

Clock setting

The system only supports 12-hour time mode.

1In active mode, press CLOCK•TIMER

(CLOCK on the remote) repeatedly until the time digits flash.

2 Press ALBUM-/+à á(à áon the remote) repeatedly to set the hour.

3Press TITLE -/+ í / ë (ALBUM/PRESET +/- on the remote) repeatedly to set the minute.

4Press CLOCK•TIMER (CLOCK on the remote) again to store the setting.

➜ The clock starts working.

To exit without storing the setting

●Press Çon the system.

Notes:

–The clock setting will be cancelled when the power cord is disconnected or if a power failure occurs.

–During clock setting, if no button is pressed within 70 seconds, the system will exit clock setting mode automatically.

Timer setting

The system can switch on to CD or TUNER mode automatically at a preset time, serving as an alarm to wake you up.

IMPORTANT!

– Before setting the timer, ensure that the clock is set correctly.

1 Press and hold CLOCK•TIMER on the front panel of the system for more than two seconds or press TIMER on the remote to select timer mode.

➜ The last timer setting starts flashing. ➜ The selected source will be lighted.

2Press SOURCE (CD or TUNER on the

remote) to select the desired source.

●You can press DISC 1/2/3/4 (CD 1/2/3/4 on the remote) to select the specific disc you would like to play.

●Before setting timer, make sure the music source has been prepared.

CD Ð Load the disc(s).To start from a specific track, make a program (refer to ÒCD/MP3 CD Operation - Programming the disc tracksÓ).

TUNER Ð tune to the desired radio station.

3 Press ALBUM-/+à á(à áon the remote) repeatedly to set the hour for the timer to start.

21