INSTALLATION
INSTRUCTIONS
1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2.Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance
to work less efficiently. If installed next to a source of heat or freezer, maintain the following minimum side clearances:
From Cookers 50 mm (2”) From Radiators 300 mm (12”) From Freezers 25 mm (1”)
3.Make sure that sufficient room is provided around the appliance to ensure free air circulation. Fit the Two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance
(See Diagram).
4.The fridge/freezer should be located on a smooth surface. The two front feet can be adjusted as required. To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or
5.Refer to cleaning and care section to prepare your appliance for use.
A special receptacle is supplied to store the mains plug during transit.
The receptacle is fixed at the back of the cabinet, on the side of the compressor. (See diagram) Gently remove the plug from the receptacle.
Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.
8
EN