SUGGESTED ARRANGEMENT OF FOOD IN THE LARDER FRIDGE
6
5
4
1
1
2 | 7 |
3 |
Arrangement Examples (See diagram).
1.Baked, chilled cooked food, dairy products.
2.Meat, sausages, cold cuts, cans.
3.Fruit, vegetables, salads.
4.Tubes, small bottles and cans.
5.Egg tray.
6.Butter, cheese, dairy products.
7.Beverages, large bottles.
The following guidelines and recommendations are suggested to obtain the best results and storage hygiene.
1.Appliance is for the short term storage of fresh food and drinks.
2.Cooked dishes must be stored in airtight covered containers and are best placed on either of the removable shelves.
8
3.Fresh wrapped produce can be placed on the shelf. Fresh fruit and vegetables should be cleaned and stored in the crisper bins.
4.Bottles can be placed in the door section.
5.To store raw meat, wrap in polythene bags and place on the lowest shelf. Do not allow to come into contact with cooked food to avoid contamination. For safety, only store raw meat for two to three days.
6.Shelves incorporate rear stops and tilting for storing bottles. Lift shelf to clear grooves when adjusting.
7.To tilt a shelf place the back of the shelf one level below the front of the shelf. To remove a tilted shelf, first release the back off the grooves and then pull it.
8.Keep the food packed, wrapped or covered. Allow hot food and beverages to cool before placing them in the fridge. Do not store explosive substances in the refrigerator. High proof alcohol must be stored upright in
sealed containers. Left over canned food should not be stored in the can.
9.Some fruit and vegetables suffer damage if kept at temperatures near 0 degrees centigrade. Therefore wrap pineapples, melon, cucumbers, tomatoes and similar produce in polythene bags.
10.Shelves, racks, crisper bins, dairy compartments, drawers, bottle grippers are all removable.
11.Always wrap food using a suitable packaging material before storing in your appliance to avoid contact with the appliance surface and food remains for hygiene reasons.
TEMPERATURE CONTROL AND ADJUSTMENT | 5 | |
Operating temperatures are controlled by the thermostat (see |
|
|
diagram). Settings may be made from 1 to 5, the coldest position. |
|
|
When the appliance is switched on for the first time, the |
|
|
thermostat should be adjusted so that after 24 hours, the |
|
|
average fridge temperature is no higher than +5°C (+41°F ). | 4 | |
We recommend you set the thermostat half |
|
|
way between the 1 and 5 setting and monitor |
|
|
|
| |
to obtain the desired temperature i. e. towards 5 you will | 3 | |
obtain a colder fridge temperature and vice versa. Some sections | ||
of the fridge may be cooler or warmer ( such as the salad crisper |
|
|
and the top part of the cabinet ) which is quite normal. |
|
|
Over ambient temperatures of 25°C (77°F) especially in | 2 | |
summer turn the thermostat knob towards 5. Under |
|
|
|
|
ambient temperatures of 25°C (77°F) turn the thermostat knob | 1 | ||
to a half way position. | |||
|
| ||
Frequent door opening cause higher internal temperatures, so | 0 | ||
close the door as soon as possible after use. | |||
|
|
In case of a temporary ice build up in the fridge compartment reduce the thermostat setting to 1, monitoring at the same time that the fridge temperature is
maximum +5 degrees C (41 degrees F). Once the ice build up disappears and the appliance starts auto defrosting again as normal, then you may increase the thermostat setting, if required.
9