Beko TF546APS, TF546APW manual

Page 10

3. Gently prise off plastic hinge covers on both sides of front top panel using a small flat-headed screwdriver. (1-2)

4.Unscrew the bolts of the top hinge and remove top hinge. (3)

5.Remove door carefully off the bottom hinge and stand door upright in a safe place.(4)

6.Gently prise off plastic hinge cover on door top trim. Fit the other door top trim plastic off hinge cover supplied in the plastic bag.(5)

7.Gently tilt the appliance back against a strong wall on its rear side sufficiently to allow the lower hinge to be removed. Take care to protect the appliance, your wall and floor coverings. You can utilise the original packaging to do this.Once you tilt the appliance back, check to make sure the appliance is completely stable and safe before you carry on. (6)

8.Unscrew and remove the front feet and 1 bolt. (7)

9.Unscrew and remove the bottom hinge. (8)

10.Unscrew and remove the bottom hinge door stopper and bushing and reposition them on the other side while rotating the bushing 180°. (9)

11.Fit the bottom hinge and tighten the screws as shown in figure. (10)

12.Fit the other front feet as shown in figure. (11)

13.Rotate the top hinge 180°. Unscrew the hinge pin and re-tighten it to the opposite side. (12)

14.Fit the top hinge on the left hand side bushing of the door. (13)

15.Locate and re-fit door to bottom hinge pin. (14)

16. Re-fit the upper hinge on the opposite side by using a flat headed screwdriver. (15)

17.Fit front top panel plastic hinge covers on the opposite sides. (16)

18.Remove the handle cover gently taking care not to damage the appliance.(17)

19.Rotate 180 degrees and fit handle to the other side after removing hole plugs gently.(19)

20.Adjust the two front feet if necessary.

21.Check that door opens and closes easily, it is aligned correctly and there are no gaps allowing air into the cabinet. If here are gaps between the door seal and the cabinet, adjust the door seal by gently pulling away from the door using fingers.

22.Check that all the hinge screws are tightened. Avoid over tightening the screws.

23.Put all items, fittings back in the appliance.

24.Wait for at least 4 hours to allow the system to settle before switching on.

25.Once the correct storage temperatures have been reached in the appliance, put back all the food.

9

EN

Image 10
Contents TF546APW TF546APS Please read this manual first Symbols and their descriptionsThis manual Maintenance Cleaning Dos and Donts InstallationUsing your refrigerator Your refrigeratorYour refrigerator Page Electrical Requirements Important! Fitting a Different PlugEnergy Saving Tips Installation Installation InstructionsReversing the Doors Page 180 Starting Before operatingFinal Check Temperature Control and Adjustment Using your refrigeratorFreezing Fresh Food Storing Frozen Food DefrostingMaking ice cubes Maintenance and cleaning Dos and Donts Problem Solving What is not covered? What is covered?Important notes HOW to Obtain Service Date of purchasePart no 57 1296