3Installation
INSTALLATION
INSTRUCTIONS
1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2.If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:
From Cookers | 2” | (50 mm) |
From Radiators | 12” | (300 mm) |
From Refrigerators or Freezers 1”
(25 mm)
3.Make sure that sufficient room is provided around the appliance to ensure free air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the appliance and the ceiling or the underside of a wall cupboard.
4.Fit the two plastic wall spacers supplied onto the condenser at the back of the appliance by rotating them 1/4 turn.
5.The appliance should be located on a smooth surface.
The two front feet can be adjusted as required.
To ensure that,your appliance is standing upright adjust the two front feet by turning clockwise or anti- clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.
6.Refer to “Cleaning and Care” section to prepare your appliance for use.
7.A special receptacle is supplied to store the mains plug during transit.
The receptacle is fixed at the back of the cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage. transit provided to avoid transit damage.
7
EN