3Installation
TRANSPORTATION
INSTRUCTIONS
1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its right hand side when standing in the frontof the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3.Failure to comply with the
above instructions could result in damage occuring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
5.When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.
6.Empty any water in the drain
tray before moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further information.
7.Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.
Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
“IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying
/moving the appliance, to avoid the mains cable becoming cut or damaged.”
Do not allow children to play with the appliance or tamper with the controls.
BEKO declines to accept any liability should the instructions not be followed.
8
EN