Transportation Instructions

1.The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage occuring

to the appliance. The manufacturer will not be held responsible if these instructions are disregarded.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5.Empty any water in the drain tray before moving see section “Defrosting” and “Cleaning & Care” for further information.

IMPORTANT : Make sure the plastic evaporating pan at the back of the product collects water properly.

IMPORTANT : Care must be taken while cleaning / carrying the appliance to avoid touching the bottom of the condenser metal wires at the back of the appliance as you might injure your fingers and hands.

Important : This appliance is not designed for stacking with any other appliance.

When positioning your appliance, take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle.

Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.

"IMPORTANT: Make sure that mains cable is not caught under the appliance during and after carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:

From Cookers	2"	(50 mm)

From Radiators	12"	(300 mm)

From Refrigerators or Larder fridges	1" (25 mm)

2. No gap is required at sides and top. See item 3 below to ensure a gap is obtained at the rear of the appliance. If a gap is available on side and top, retain it if possible as it would improve the air circulation around the appliance.

3. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (see diagram).

4.The appliance should be located on a smooth

surface. The two front feet can be adjusted as required. To ensure that, your appliance is standing upright adjust the two front feet by turning clockwise or anti-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise.

5.Refer to "Cleaning and Care" section to prepare your appliance for use.

6.This appliance has been designed to operate in ambient temperatures beetween +10 and +32 degrees C (50 and 90 degrees F).Therefore if the appliance is installed in an unheated / cold room (E.g.: Conservatory / annex / shed / garage etc.) then the food in the larder fridge [In particular salad, fruit, water and fruit juices] will start freezing because of the cold ambient temperature when the temperature drops below 0 C [Zero degrees Centigrade]. The appliance will resume normal operation when the ambient temperature rises back above +5 C. Please note, between 0 C and +5 C, the compressor will not run but the temperature in the larder fridge will be safe to store your food anyway. So don't worry when the compressor does not operate between 0 C and +5 C.

7.A special receptacle is supplied to store the mains

plug during transit. The receptacle is fixed at the back of the cabinet, on the right hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation, ensure you locate the plug in the receptacle provided to avoid transit damage.

8.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

LA 87, LA 120, LA 85 specifications

Beko, a renowned brand in the home appliance sector, has made a significant mark with its range of advanced washing machines, including models like the LA 85, LA 120, and LA 87. These washers not only enhance the efficiency of laundry tasks but also incorporate innovative technologies aimed at providing superior cleaning performance while being environmentally friendly.

The Beko LA 85 is a compact washing machine tailored for small households or those with limited space. This model offers a generous capacity, accommodating up to 8 kg of laundry. One of its standout features is the Quick Wash program, which allows users to get a full load of laundry done in just 28 minutes, ideal for busy lifestyles. The LA 85 is also equipped with an Eco mode, ensuring energy-efficient washing without compromising on cleanliness. Its digital display makes operation intuitive, allowing users to easily select programs and options.

Moving on to the Beko LA 120, this model is designed for mid-sized households and offers an impressive 12 kg capacity. What sets the LA 120 apart is its advanced ProSmart Inverter Motor, which guarantees quieter operation while also being more energy-efficient compared to traditional motors. This machine is outfitted with a variety of washing programs, including a SteamCure option that utilizes steam to reduce wrinkles and sanitize fabrics, making it a great choice for allergy sufferers. Additionally, the LA 120 boasts a Child Lock feature, enhancing safety in homes with young children.

Lastly, the Beko LA 87 appeals to users seeking a balance between capacity and advanced features. This model also supports an 8 kg capacity and incorporates Beko's innovative AquaTech technology, which uses dynamic water flow to achieve better washing results while being gentler on fabrics. The LA 87 includes a special Anti-Stain program that targets and removes stubborn stains at lower temperatures, promoting energy savings. Furthermore, this model's robust build quality ensures durability, making it a long-lasting addition to any laundry space.

In summary, the Beko LA 85, LA 120, and LA 87 washing machines feature a blend of efficient washing capabilities, innovative technologies, and user-friendly designs. Whether you are a single individual, a small family, or someone looking for advanced washing solutions, these models present options that cater to various needs while prioritizing sustainability and performance.