11.Reposition plugs and hinge pin bushings on top of doors on the opposite side of both doors. Use small
flat-h e a d e d screwdrivers to remove plugs and bushings. Take care not to mark doors.
(9)
12.Reposition left hand side feet on the opposite side.(10)
13.Unscrew and remove the upper door middle hinge pin bushing/ door stopper using a
screwdriver. Important: This part cannot be used on the opposite side; left hand side middle hinge pin
bushing/door stopper part is supplied in the plastic bag.(11)
14.
15.Fit upper door left hand side middle hinge pin bushing/door stopper supplied in the plastic bag using
16.Reposition three small plastic plugs on the left hand side, which are covering middle hinge holes, on the
opposite side to cover holes left empty.(14)
17.Locate and
18.Locate the middle hinge pin to middle hinge pin bushing of upper door on the left hand side and
middle hinge.(16)
19.Reposition the two screws fitted to lower hinge holes on the left hand side at the bottom of the cabinet
on | the opposite |
side.(17) |
|
20.Unscrew and reposition the hinge housing and steel pant on the right hand side at the bottom of the door on the
opposite side. (18)
21.Locate and
(20)
22.Carefully stand the appliance upright and adjust the two front feet if necessary.
23.Check that doors open and close easily, they are aligned correctly and that there are no gaps allowing
air into the cabinet. If there are gaps between the door seal and the cabinet, adjust the door seal by
gentlypulling away from the door using fingers.
24.Check that all the hinge screws are tightened. Avoid over tightening the screws.
25.Put all items, fittings back in the appliance.
26.Fit upper door top trim plastic hinge cover. Upper door top trim hinge cover is supplied in the plastic bag.(21)
27.Wait for at least 4 hours to allow the system to settle before switching on.
28.Once the correct storage temperatures have been reached in the appliance, put back all the food.
11
EN