•The voltage stated on the label located at left inner side of your product should be equal to your network voltage.
•Extension cables and multi plugs must not be used for connection.
BA damaged power cable must be replaced by a qualified electrician.
BProduct must not be operated before it is repaired! There is the risk of electric shock!
Disposing of the packaging
The packing materials may be dangerous for children. Keep the packing materials out of the reach of children or dispose of them by classifying them in accordance with the waste instructions stated by your local authorities. Do not throw away with regular house waste, throw away on packaging pick up spots designated by the local authorities.
The packing of your cooler/freezer is produced from recyclable materials.
Disposing of your old cooler/ freezer
Dispose of your old cooler/freezer without giving any harm to the environment.
•You may consult your authorized dealer or waste collection center of your municipality about the disposal of your cooler/freezer.
Before disposing of your cooler/freezer, cut out the electric plug and, if there are any locks on the door, make them inoperable in order to protect children against any danger.
Placing and Installation
A If the entrance door of the room where the cooler/freezer will be installed is not wide enough for the cooler/freezer to pass through, then call the authorized service to have them remove the doors of your cooler/ freezer and pass it sideways through the door.
1.Install your cooler/freezer to a place that allows ease of use.
2.Keep your cooler/freezer away from heat sources, humid places and direct sunlight.
3.There must be appropriate air ventilation around your cooler/freezer in order to achieve an efficient operation. If the cooler/ freezer is to be placed in a recess in the wall, there must be at least 5 cm distance with the ceiling and at least 5 cm with the wall. Do not place your product on the materials such as rug or carpet.
4.Place your cooler/freezer on an even floor surface to prevent jolts.
Adjusting the legs
If your refrigerator is unbalanced;
You can balance your refrigerator by turning its front legs as illustrated in the figure. The corner where the leg exists is lowered when you turn in the direction of black arrow and raised when you turn in the opposite direction. Taking help from someone to slightly lift the refrigerator will facilitate this process.
Changing the illumination lamp
To change the Bulb/LED used for illumination of your refrigerator, call your Authorized Service.
9
EN